Table of Contents
Advertisement
Playing an iPod
®
To Play an iPod
®
This audio system can operate the
audio files on the iPod
®
same controls used for the in-dash
disc changer. To play an iPod,
connect it to the USB adapter cable
in the console compartment by using
your dock connector, then press the
DISC/AUX button. The ignition
switch must be in the ACCESSORY
(I) or ON (II) position. The iPod will
also be recharged with the ignition
switch in these positions.
The system will only play songs
stored on the iPod with iTunes.
iPod and iTunes are registered
trademarks owned by Apple Inc.
Voice Control System
You can select the AUX mode by
using the navigation system voice
control buttons, but cannot operate
the play mode functions.
262
(Models with navigation system)
iPod models confirmed to be
compatible with your audio system
with the
using the USB adapter cable are:
iPod classic 80/160 G
iPod classic 120 G
iPod classic 160 G (launch in 2009)
iPod (5th generation)
iPod nano
iPod touch
This system may not work with all
software versions of these devices.
Model
NOTE:
Do not connect your iPod using a
●
hub.
Do not keep the iPod in the
●
vehicle. Direct sunlight and high
heat will damage it.
Do not use an extension cable
●
between the USB adapter cable
equipped with your vehicle and
your dock connector.
We recommend backing up your
●
data before playing it.
Some devices cannot be powered
●
or charged via the USB adapter, if
this is the case use the accessory
adapter to supply power to your
device.
Advertisement
Table of Contents
