Steering Lever Adjustment - Ferris UltraBelt GD BGF36KAV15 Operator's Manual

STEERING LEVER ADJUSTMENT

There should be approximately 2" (5,1cm) of clearance
in between the handle bars and the steering levers when
the clutch lock levers are disengaged (see Figure 10).
To adjust:
1. Remove the hair pin and washer that retains the bar-
rel nut in the clutch plate (see Figure 10).
2. Turn the barrel nut up or down the rod and reinstall
the barrel nut, washer and hair pin.
3. Remeasure the distance and repeat adjustment until
desired measurement is achieved.
4. Repeat adjustment procedure for other side of
machine.
Troubleshooting, Adjustment & Service
Figure 10. Steering Lever Adjustment
19
2"
(5,1cm)
ADJUST HERE