Calibrating Depth Scale; Setting Fence Stops - Grizzly G0604X EXTREME SERIES Manual Insert

Figure 60. Depth scale adjusted to "0" position.
-40-

Setting Fence Stops

The fence stops simplify the task of adjusting the
fence to 45˚ inward, 90˚, and 45˚ outward (135˚).
Tools Needed
45° Square ........................................................ 1
90° Square ........................................................ 1
Sliding Bevel ...................................................... 1
Wrench 10mm ................................................... 1
Hex Wrench 4mm .............................................. 1
To set the 45˚ inward fence stop:
1.
Tilt the fence approximately 45° inward
(Figure 61) onto the positive stop bolt.
Figure 61. Fence adjusted 45˚ inward.
2.
Loosen the jam nut on the 45° inward positive
stop bolt shown in Figure 62.
3.
Adjust the positive stop bolt until the fence is
exactly 45° inward while resting on the bolt
(verify the angle with a 45° square).
4. Retighten the jam nut loosened in Step 2.
Qty
G0604 6" X 56" Jointer