Name Of Parts - Fujitsu Halcyon ASU18T Operating Manual

NAME OF PARTS

Fig. 1 Indoor Unit
Operating Control Panel (Fig. 2)
MANUAL AUTO button
Remote Control Signal Receiver
Indicator Lamps (Fig. 3)
OPERATION Indicator Lamp (red)
TIMER Indicator Lamp (green)
● If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(see page 17 Auto Restart).
SWING Indicator Lamp (orange)
Intake Grille (Fig. 4)
Air Filter
Air Flow Direction Louver
Right-Left Louvers
(behind Air Flow Direction Louver)
Drain Hose
Inter Unit-Line
Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
Power Supply
Intake Port
Outlet Port
Pipe Unit
Drain port (bottom)
En-4
Fig. 6 Remote Control Unit
SLEEP button
MASTER CONTROL button
SET TEMP./SET TIME button (
Signal Transmitter
TIMER button
FAN CONTROL button
START/STOP button
AIR FLOW DIRECTION button
SWING LOUVER button
Rear side (Fig. 7)
TIME ADJUST button
ACL button
(located inside battery compartment)
TEST RUN button
● This button is used when installing the
unit, and should not be used under nor-
mal conditions, as it will cause the air con-
ditioner's thermostat function to operate
incorrectly.
● If this button is pressed during normal op-
eration, the unit will switch to test opera-
tion mode, and the Indoor Unit's OPERA-
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
● To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
Remote Control Unit Display (Fig. 8)
Transmit Indicator
Clock Display
Operating Mode Display
Timer Mode Display
Fan Speed Display
Temperature Set Display
Timer Set Indicator
Temperature Set Indicator
)