Swing Operation - Fujitsu Halcyon ASU18T Operating Manual

SWING OPERATION

Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING LOUVER button (Fig. 6
The SWING indicator lamp (orange) (Fig. 3
In this mode, the Air Flow Direction Louvers will swing automatically to direct
the airflow both up and down.
To Stop SWING Operation
Press the SWING LOUVER button (Fig. 6
The SWING indicator lamp (orange) (Fig. 3
Airflow direction will return to the setting before swing was begun.
About Swing Operation
● The SWING range is as follows:
Cooling/Dry
mode
Fan mode
● The SWING operation may stop temporarily when the air
conditioner's fan is not operating or when operating at
very low speeds.
● The airflow direction can not be adjusted during SWING
operation even when the AIR FLOW DIRECTION button is
pressed.
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2
unit control panel.
To stop operation, press the MANUAL AUTO button once again.
(Controls are located inside the Intake Grille.)
) will light.
) will go out.
, ( ) NOTE
,
).
) once again.
NOTE
The air swings between
LOUVER button after selecting the air direction
ward) by pressing the AIR FLOW DIRECTION button.
Use this operation when you want to cool yourself for a
while after taking a bath or shower, or after coming back
home in summer months.
But, for prevention of condensation on the louver, the
swing of the air direction
after 30 minutes and turned to the swing of the air direc-
↔
tion .
) on the main
● When the air conditioner is operated
● The fan speed selected will be
and by pressing the SWING
(down-
↔
is automatically released
with the controls on the Main unit, it
will operate under the same mode as
the AUTO mode selected on the Re-
mote Control Unit (see page 8).
"AUTO" and the thermostat setting
will be standard.
En-17