Preparation - Fujitsu Halcyon ASU18T Operating Manual

PREPARATION

Turn on the Power
In the case of a direct line connection, turn on the circuit
breaker.
Load Batteries (AAA × 2)
1 Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the
Insert batteries.
2
Be sure to align the battery polarities (
Close the battery compartment lid.
3
Set the Current time
Press the TIME ADJUST button (Fig. 7
1
Use the tip of a ball-point pen or other small object to press the button.
Use the
2
to adjust the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute steps.)
Press the TIME ADJUST button again.
3
This completes the time setting and starts the clock.
To Use the Remote Control Unit
● The remote control unit must be pointed at signal receiver (Fig. 1
correctly.
● Operating range: About 7 meters.
● When a signal is properly received by the air conditioner, a beep be heard.
● If no beep is heard, press the remote control unit button again.
Remote Control Unit Holder
Insert
Press in
Screws
Mount the Holder. Set the Remote Control
Unit.
) correctly.
SET TEMP./SET TIME buttons (Fig. 6
Slide up
Pull out
To remove the Remote
Control Unit .
CAUTION!
● Take care to prevent infants from acciden-
tally swallowing batteries.
● When not using the remote control unit
for an extended period, remove the bat-
teries to avoid possible leakage and dam-
age to the unit.
● If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of wa-
ter, and consult your physician.
● Dead batteries should be removed quickly
and disposed of properly, either by plac-
mark.
ing in a public battery collection recepta-
cle, or by returning to appropriate author-
ity.
● Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the remote control
unit's operating range becomes appre-
ciably reduced, replace the batteries and
press the ACL button (Fig. 7
the tip of a ballpoint pen or other small
object.
).
)
) to operate
) with
En-7