Setup Menu With Auxiliary; Video Source Selected - Zenith PV5268RK Operating Manual And Warranty

Projection color tv mts stereo picture-in-picture closed captions universal remote control
Table of Contents

Advertisement

SETUP MENU
PROJO
(Projection)
SETUP
Purpose
Lets you verify and adjust, if needed, the dynamic color con-
vergence of the TV.
Your projection TV has three separate projection picture
tubes, one for each primary color: red, green and blue. To
obtain a good color pictm;e, it is necessary that all three
colors are aligned exactly. This alignment is called "conver-
gence."
Your TV was properly converged at the factory. However,
in.some cases, the convergence may be affected depending
on where you place the TV.
If you move your TV from its original location, or if after
time, you notice color "fringes" in the picture, you may want
to realign the colors by adjusting the convergence as
described in the following steps.
B_efore Using PROJO SETUP
1.
Place the TV in its permanent
location.
2.
Turn the TV on and select
an active channel.
Let
the TV warm up for a few minutes.
SETUP MENU
,
4.
5.
If the display appears
as fou_: white right-angle
lines
as shown at the right, no adjustment
is necessary.
If there
are more than four lines, each a different
color, you must adjust
the convergence.
Use the SELECT
and ADJUST
arrow
keys (Up,
Down, Left and Right)
to adjust
the Red lines until
they are on top of the Green lines.
Use MENU
to change
the test color to Blue.
Use the SELECT
and ADJUST
arrow
keys (Up,
Down, Left and Right) to adjust
the Blue lines until
they are on top of the other
lines.
All lines should
now be white.
6.
Press ENTER
to return
to normal viewing.
NOTES:
While the Blue test color is Sl_LOWing, the following mes-
sage appears at the bottom of '_Lhe s creen.
PRESS ARROW
KEYS TO CONVERGE
BLUE
While the Red test color is showing, the following message
appears at the bottom of the screen.
PRESS ARROW KEYS TC, CONVERGE
RED
AUTO CH. SEARCH
CH. ADD/DEI.
CH. LABELS
TUNING BAI_D
AUTO FINE TUNE
CLOCK SET
CAPTIONS
CH. BACKGROUND
")" PROJO SETUP
TO CONVERGE
Selecting Projo Setup
To Use PROJO SETUP
1.
PROJO
SETUP
slhould be selected
if you followed
the "Basic
Menu
Operation"
given
in the "On-
Screen
Menu" section.
2.
With PROJO
SETUP
highlighted,
press ADJ
(Ad-
just)
lzeft/Right
to view the convergence
lines.
[
1I
Good Convergence
Bad Convergence
SETUP MENU WITH AUXILIARY
VIDEO SOURCE
SELECTED
If one of the auxiliary video sources (VIDEO 1, VIDEO 2,
VIDEO 3, S-VIDEO 1 or S-VIDEO 2) is selected for your
main viewing picture, many of the SETUP MENU options
will not appear when the SETUP MENU is accessed. The
illustration below show.,; the SETUP MENU as it would ap-
pear. Only the CLOCK SET, CAPTIONS,
CH. BACK-
GROUND
and PROJO SETUP options remain. Refer to
the earlier discussions when setting these options.
SETUP MENU
-_ CLOCK SET
CAPTIONS
CH. BACKGROUND
PROJO SETUP
Setup Menu for Video and S-Video Sources
_so-o
9 - 6

Advertisement

Table of Contents
loading

Table of Contents