Zenith DVD2250 Operating Manual & Warranty page 39

Selecting Digital Audio Output
Each DVD disc has a variety of audio output
options. Set the player's Digital Audio Output
according to the type of audio system you use.
zcera rr, a d_m
®®®
®®®
OUTPUT
Playback
Disc _by Digital/ PCM only
48kHz, 16 bit 48 _J-Iz,16 bil 48 kHz, 16 bit
PCM DVO Linear PCM Unear PCM
48kH=, 20/'24 bit 48 kHz, 20 i_l 48 I_z, 20 bit
PCM DVD Linear PCM Linear PCM
96 Id.lz
Linear PCM Not Output Not Output
DVD
DTS DVO NO_ Output Not Output
Dolby Digital D0;by Distal 48 kHz, 16 bit
DVD bit Stream PCM
MPEG DVD 48 kHz, 16 bit 48 kHz, 16 bit
Linear PCM Linear PCM
Audio CD
OTS Audio CD
Stmam/PCM
48 kHz, I 6 bit
Unear FCM
48 kHz, 20 bit
Unear PCM
Not O utput
DTS bit Stream
OcJby D_al
bit Stream
MPEG bit Stream
44.1 kHz, 16 bit
Unear PCM
DT$ bit Stream
44.1kHz,16 blt
Linear FCM
DTS bit Stream
44.1 kHz, 16 bit
Unear PCM
DTS b_ Stream
INITIAL SETUP OPERATION PAGE 39
At the SETUP screen.
D Press _ to select Digital Audio Output and
press I_.
B Press A/F to select the desired output and
press SELECT.
DOLBY DIGITAL/PCM: Select =DOLBY DIGITAL/PCM" if
an active digital output is supplied to dolby
digital decoder, (or an amplifier or other equipment with dolby
digital decoder).
StreandPCM: Select =Stream/PCM" if an active
digital output is supplied to an amplifier or other
equipment with DTS decoder, dolby digital decoder and
MPEG decoder.
PCM: Select =PCM" if an active digital output is
supplied to an amplifier or other equipment with linear PCM
only (or MD recorder or DAT deck).
• When you are not using the player's digital audio output, don't
select any of the options.
• If an active digital audio output signal is supplied to an receiver or
other equipment without a corresponding digital decoding capabil-
ity, a very loud noise may be produced which could permanently
damage the speakers.