Level The Washer; Complete Installation - Whirlpool Duet Steam WFW9600TW02 Use & Care Manual

Properly leveling yourwasher avoids e xcessive noise and
vibration.
1. Check t helevelness ofthewasher byplacing a level o nthe
topedge ofthewasher, firstside toside, t henfront t oback.
\ L
1__/_t ¸_
1. Check t heelectrical requirements. Besure thatyouhave the
correct electrical supply and therecommended grounding
method. See "Electrical Requirements."
2. Check t hatallparts arenow installed. Ifthere isanextra part,
goback through t hesteps toseewhich step wasskipped.
3. Check t hatyouhave allofyourtools.
4. Dispose of/recycle allpackaging materials.
5. Check t hatthewater f aucets a reon.
6. Check f orleaks a round f aucets a nd inlet h oses.
Ifthewasher isagainst awall, m ove thewasher outslightly
before t ipping back. I fthewasher isnotlevel, firstprop the
front w ithawood block and adjust thefeetasnecessary;
thenprop theback and adjust feetasnecessary. Repeat this
step until w asher islevel.
2. Make sure allfour feetare stable and resting o nthefloor.
Then check thatthewasher isperfectly level ( use alevel).
3. After t hewasher islevel, usea 17mmopen-end wrench t o
turn thenuts onthefeettightly against thewasher cabinet.
IMPORTANT: Allfourfeet m ust b etightened. Ifthenuts are
nottightagainst thewasher cabinet, thewasher may vibrate.
4. The washer should n otmove front t oback, s ide toside, o r
diagonally when pushed o nitstopedges.
5. Slide thewasher toitsfinal l ocation.
6. Confirm thelevelness ofthewasher.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
7=
8.
9.
Plug into a grounded 3 prong outlet.
Read "Washer Use."
To test and clean your machine, make sure there are no
clothes in the washer and add one AFFRESH
TM
tablet to the
washer drum. Select Power, the Clean Washer cycle and then
select START. This cycle will take approximately 67 minutes
to complete. Allow the washer to complete the entire cycle
without interruption.
10