Foxconn 915G7MC User Manual page 25

Addtional COM Header: COM2
This motherboard provides an additional serial COM
header for your machine.
Connect one side of a switching cable to the header,
then attach the serial COM device to the other side of
the cable.
1394 Header: F_1394 (optional)
The 1394 expansion cable can be connected to either
the front (provided that the front panel of your chassis
is equipped with the appropriate interface) or real
panel of the chassis.
IrDA Header: IR
This header supports wireless transmitting and receiv-
ing device. Before using this function, configure the
settings of IR Mode from the "Integrated Peripherals"
section of the CMOS Setup.
Chassis Intruder Header: INTR
The connector connects to the chassis security switch on the case. The system
can detect the chasis intrusion through the status of this connector. If the con-
nector has been closed once, the system will send a message. To utilize this
function, set "Case Open Warning" to "Enabled" in the "PC Health Status" sec-
tion of the CMOS Setup. Save and exit, then boot the operating system once to
make sure this function takes effect.
18
Chapter 2 Installation Instructions
SOUT
GND
RTS#
+12V
TPB -
GND
TPA -
1 INTRUDERJ
1 2
SIN
DTR#
DSR#
CTS#
RI#
Empty
9 10
COM2
10 9
Empty
+12V
TPB +
GND
TPA +
2 1
F_1394
1
+5V
Empty
IRRX
GND
IRTX
IR
2 GND
INTR