Whirlpool GS440LEMQ5 Use & Care Manual page 9

All Tones: All of the above tones are preset on. All except the
end-of-cycle tones can be turned off.
To Turn Off/On (on some models): Press and hold START TIME
for 5 seconds. A tone will sound, and "Snd OFF" will appear on
the display. Repeat to turn tones on, and "Snd on" will appear on
the display.
On some models, only the loudness of the tones can be adjusted.
On other models, the tones cannot be adjusted or turned off.
Tone Pitch: The pitch is preset at high, but can be changed to
low. On some models, only the loudness of the tones can be
adjusted. On other models, the tones cannot be adjusted or
turned off.
To Change (on some models): Press and hold BAKE for
5 seconds. A tone will sound, and "Snd LO" will appear on the
display. Repeat to change, and "Snd Hi" will appear on display.
The temperature is preset at Fahrenheit, but can be changed to
Celsius on some models.
To Change: Press and hold CUSTOM BROIL for 5 seconds. A
tone will sound, and "°C" will appear on the display. Repeat to
change back to Fahrenheit. To exit mode, press CANCEL or
OFF/CANCEL
The Timer can be set in hours or minutes up to 12 hours and
59 minutes, and counts down the set time. The Timer does not
start or stop the oven.
To Set:
1. Press TIMER SET or TIMER CANCEL*. The timer indicator
light will light up on some models. If no action is taken after
5 minutes, the display will return to the time of day mode.
2. Depending on your model, press the HR or MIN or TIME/
TEMP "up" or "down" arrow pads to set the length of time to
cook.
3. Press START or TIMER SET. When the set time ends, end-of-
cycle tones will sound, then, if enabled, reminder tones will
sound every minute on some models.
4. Press TIMER OFF or TIMER CANCEL* anytime to cancel the
Timer and reminder tones.
Remember, do not press the CANCEL pad because the oven
will turn off.
To display the time of day for 5 seconds when the timer is
counting down, press CLOCK.
The Control Lock shuts down the control panel pads to avoid
unintended use of the oven.
When the control is locked, only the ACCUSlMMER ®,CLOCK
SET, OVEN LIGHT (on some models) and TIMER pads will
function.
To Lock/Unlock Control: Before locking, make sure the oven
and Timer are off. Press and hold START for 5 seconds. A single
tone will sound, and "Loc" will appear on the display.
Repeat to unlock. "Loc" will disappear from the display.
IMPORTANT: Do not use a thermometer to measure oven
temperature because opening the oven door may cause burner
cycling to give incorrect readings.
The oven provides accurate temperatures; however, it may cook
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit or
Celsius.
A minus sign means the oven will be cooler by the displayed
amount. The absence of a sign means the oven will be warmer by
the displayed amount. Use the following chart as a guide.
ADJUSTMENT °F COOKS FOOD
(ADJUSTMENT °C)
10°F (5°C) ...a little more
20°F (10°C) ...moderately more
30°F (15°C) ...much more
-10°F (-5°C) ...a little less
-20°F (-10°C) ...moderately less
-30°F (-15°C) ...much less
To Adjust Oven Temperature Calibration:
1. Press and hold BAKE for 5 seconds until the oven display
shows the current calibration, for example "0°F CAL" or "00."
2. Press the TEMP or TEMP/TIME "up" or "down" arrow pad(s)
to increase or to decrease the temperature in 10°F (5°C)
amounts. The adjustment can be set between 30°F (15°C)
and -30°F (-15°C).
3. Press START or START/ENTER.