Festool C 12 Li Instruction Manual page 12

WH-CE
5-1 5-2 5-3 5-4
Detaching the CENTROTEC
Pull the release ring [5-3] forwards.
Remove the tool chuck.
Changing tools
Pull back the green release ring [5-2] to attach or
detach tools with a CENTROTEC shank.
When attaching the tool, rotate until the hexagon
shank [5-1] engages in the hexagon holder on the
drill spindle.
Release the ring [5-2].
Chuck BF-FX
The chuck BF-FX is used for clamping drill and
screwdriver bits.
BF-FX
6-1 6-2
Attaching the chuck BF-FX
Attach the chuck to the drill spindle [6-5].
Pull the release ring [6-3] forwards.
Turn until the hexagon pin [6-4] on the chuck en-
gages in the hexagon socket holder in the drill
spindle.
Push the chuck all the way onto the drill spindle.
Release the ring [6-4].
Detaching the chuck BF-FX
Pull the release ring [6-4] forwards.
Remove the chuck.
Changing tools
Turn the clamping sleeve [6-2] anticlockwise to
open the clamping jaws [6-1].
12
6-3 6-4
6-5
The arrow on the spindle indicates the opening di-
rection.
Insert the tool into the chuck.
CAUTION
Risk of injury
Clamp the tool centrally in the chuck!
Turn the clamping sleeve [6-2] clockwise to
clamp the tool.
Angle attachment DD-AS
The angle attachment DD-AS (partly accessories) al-
lows you to work (drill, fasten) vertically in relation to
the longitudinal axis on the machine.
DD-AS
7
7 - 1
Fitting the angle attachment DD-AS
Fit the angle attachment to the drill spindle.
Turn the attachment until is engages in the re-
quired position.
You can engage the angle attachment in 16 differ-
ent positions.
Turn the securing ring [7-2] firmly clockwise to
lock the angle attachment.
Removing the angle attachment DD-AS
Turn the securing ring [7-2] anticlockwise all the
way.
Remove the angle attachment.
Attaching/Detaching the chuck
The chuck is secured to the shaft [7-1] of the angle
attachment and the drill spindle on the machine in
the same way.
Eccentric attachment DD-ES
The eccentric attachment (partly accessories) en-
ables you to fasten close to abutting edges. The tool
holder was designed for bits in accordance with DIN
3126.
- 2