Fellowes DS-3 User Manual page 2

See safety instructions below
SafeSense Technology (yellow)
®
Shredder head
Paper entry
Waste opening
Bin full indicator
Basket
Breakthrough Safety Technology! SafeSense stops shredding when hands are too close to the opening.
®
SET-UP — To Test SafeSense
Place head on basket
Press Auto-On ( )
as shown:
Disconnect power switch
must be in ON ( I )
position to operate
shredder.
CAPABILITIES
Will shred: Paper, small paper clips, credit cards and staples
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper,
cardboard, large paper clips, laminates or plastic other than
noted above
Paper shred size:
Cross-Cut ......................................................................... 5/32" x 2" (3.9 x 50mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Keep hands away from paper
entry. Always unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc.– away
from shredder openings. If object enters top opening, press and
15
hold Reverse (R) to back out object.
15
• Avoid touching exposed blades under Cross-Cut shredder head.
2
Safe Sense
Active
Control switch
Technology
®
Touch test area
Maximum:
Sheets per pass (Cross-Cut) .................................................................................10*
Cards per pass ....................................................................................................... 1
Passes per day ............................................................................................... 10-20
Paper width ............................................................................................9"/229mm
Continuous operation ............................................................................. 4-5 minutes
*20 lb., 8.5"x11" paper at 120v, 60 Hz, 3.8Amps; heavier paper, humidity or other than
rated voltage may reduce capacity.
Fellowes SafeSense shredders are designed to be operated in home and office
®
environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40
– 80% relative humidity.
• Never use aerosol, petroleum-based or other flammable products on or
near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not open shredder head.
Do not place near or over heat or water source.
15
• 10 sheets per pass to avoid jams.
• The socket-outlet shall be installed near the equipment and shall be easily
accessible.
ENGLISH
OPERATION
Model DS-3
Disconnect power switch
Overheated (red)
Standby (green)
Continuous operation:
Handle
4-5-minute maximum
override switch NOTE: Shredder runs briefly
®
after each pass to clear entry.
Continuous operation beyond
Not Active
Grips
4-5-minutes will trigger
20-minute cool down period.
Auto-On ( )
Off
Reverse (R)
TROUBLESHOOTING
Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the
below procedures.
Press and hold
Reverse (R)
2-3 seconds
Sensor lights up
ATTENTION: If the SafeSense
SafeSense ® feature. (See SafeSense
SafeSense paper jam: If the SafeSense
®
to think the shredder has jammed when it has not, use the
feature and clear the paper. Warning – when switch is in override position, the SafeSense
the SafeSense ®
MAINTENANCE
Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Shredder stops running
WARRANTY
LIMITED WARRANTY Fellowes, Inc. ("Fellowes") warrants the cutting blades of the machine to be free from
defects in material and workmanship for 3 years from the date of purchase by the original consumer.
Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1
year from the date of purchase by the original consumer. If any part is found to be defective during the
warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes' option and
expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED
PAPER
Press Auto-On ( )
Set to Off
CARD
Press Auto-On ( )
Set to Off (O) Gently pull uncut paper
Alternate slowly back and forth
and unplug from paper entry. Plug in.
light remains on, you must engage the Override Switch in order to perform steps above. Once the jam is cleared, reset the
®
® instructions below.)
feature activates (SafeSense light remains on) to cause the user
® ®
Override Switch to deactivate the SafeSense
feature will NOT function. Once the paper is cleared, reset the SafeSense
Follow oiling procedure below and repeat twice.
Set to Off *Apply oil Press Auto-On ( )
across entry
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY
LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall
Fellowes be liable for any consequential or incidental damages attributable to this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid
worldwide, except where different limitations, restrictions, or conditions may be required by local law.
For more details or to obtain service under this warranty, please contact us or your dealer.
Feed into paper entry
and release
Set to Off
Feed into paper entry
and release
Shredder doesn't start:
Yellow - SafeSense active
®
Yellow flashing - SafeSense ® not active
Make sure head is on basket correctly
Wait 20 minutes for motor to cool down
Remove and empty basket
Press and hold
Reverse (R)
Sensor light illuminated–paper jammed
®
light will flash and
®
® feature.
SafeSense override switch
®
Active Not active
Press and hold
Shred one sheet
Reverse (R)
2-3 seconds
15
3