Download Print this page

Weed Eater WEB200 Instruction Manual page 7

Hide thumbs Also See for WEB200:

Advertisement

Available languages

Available languages

,&
_IIWARNING:
Perform
the following
steps after each use:
• Stop unit and disconnect
from the pow-
er source.
• Allow
motor to cool before
storing
or
transporting.
• Store unit with all guards in place. Posi-
tion unit so that any sharp object cannot
accidentally
cause injury.
• Store
unit unplugged,
well out of the
reach of children.
SEASONAL
STORAGE
Prepare
unit for storage
at the end of
the season
or if it will not be used for
30 days or more.
TROUBLESHOOTING
TABLE
If your blower
is to be stored
for a period
of time:
• Stop unit and disconnect
from the pow-
er source.
• Clean the entire unit before lengthy stor-
age.
• Inspect
the
blower
and blower
tube.
Close
and
make
sure
the
cover
is
latched.
• Clean air vents and air inlet of debris.
• Store your unit and extension
cord in a
well ventilated
area and covered,
if pos-
sible, to prevent dust and dirt accumula-
tion. Do not cover
with plastic. Plastic
cannot
breathe
and may cause
con-
densation
and eventual
rust or corro-
sion.
• Check entire unit for loose screws.
Re-
place
any damaged,
worn,
or broken
parts.
_i, WARNING:
Always stop unit and disconnect from the power source before
performing all of the recommended remedies below except remedies that re-
quire unit to be operating.
SYMPTOM
CAUSE
REMEDY
Unit fails to
1. Switch
in the OFF position.
1. Slide
switch
to ON position.
operate.
2. Extension
cord discon-
2. Reconnect
extension
cord.
neoted.
3. Circuit
breaker
tripped,
or
3. Reset circuit
breaker
or
fuse blown,
fuse.
4. Mechanical
failure
4. Contact
your authorized
service
dealer.
Unit
1. Mechanical
failure
1. Contact
your authorized
vibrates
service
dealer.
abnormally.
Impeller
will
1. Debris
in air intake
area.
1. Clean
unit. Remove
any
not turn
2. Mechanical
failure,
debris.
freely.
2. Contact
your authorized
service
dealer.

Advertisement

loading