Check Condition Of Belts; Lubricate Grease Fittings; Lubricate Caster Wheel Hubs - Exmark LAZER Z XS Operator's Manual

Air-cooled models
Hide thumbs Also See for LAZER Z XS:
Table of Contents

Advertisement

system, frame, and other components. Foam filling
tires will void the warranty.

Check Condition Of Belts

Service Interval: Every 40 hours
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Unhook seat latch and tilt seat up. Lift the rubber
flap on front side of the engine to check pump
drive belt.
3. Remove left and right belt shields on deck and lift
up floor pan to inspect deck drive belt.
4. Check under machine to inspect the mule drive
belt. See Mule Drive Belt Tension Adjustment
section.

Lubricate Grease Fittings

Note: See chart for service intervals.
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2. Lubricate fittings with one to two pumps of
NGLI grade #2 multi-purpose gun grease.
Refer to the following chart for fitting locations
and lubrication schedule.
Lubrication Chart
Fitting
Initial
Locations
Pumps
1. Front
*0
Caster wheel
hubs
2. Front
*0
Caster
Pivots
3. Height
1
Adjustment
Shaft
Bearings
4. Deck
1
Drive Belt
Idler Arm
5. Brake
1
Brackets
6. Mule
1
Drive Belt
Idler Arm
Number of
Service
Places
Interval
2
*Yearly
2
*Yearly
5
40 Hours
1
Yearly
2
200 Hours
1
Yearly
Lubrication Chart
Fitting
Initial
Locations
Pumps
7. Pump
1
Drive Belt
Idler Arm
1
8. Deck
Rear Struts
* See step 3 for special lubrication instructions on
the front caster pivots and the Lubricate Caster
Wheel Hubs section for special lubrication
instructions on the front casters wheel hubs.
Number 6 (Mule Drive Belt Idler Arm) Located
Under Engine Frame
Number 7 (Pump Drive Belt Idler Arm) Located
Under Engine Frame
3. Lubricate front caster pivots once a year. Remove
hex plug and cap. Thread grease zerk in hole and
pump with grease until it oozes out around top
bearing. Remove grease zerk and thread plug back
in. Place cap back on.

Lubricate Caster Wheel Hubs

Service Interval: Yearly
1. Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
33
Maintenance
Number of
Service
Places
Interval
1
Yearly
2
40 Hours

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents