Specifications; Model Number; Specifications 2.1 Model Number; Engine - Exmark Turf Tracer Operator's Manual

2. SPECIFICATIONS

2.1 MODEL NUMBER:

TT23KCE; TT23KAE; TT20KCE

2.2 ENGINE

2.2.1 Engine Specifications: See your Engine Owner's Manual.
2.2.2 3600 RPM (No Load).

2.3 FUEL SYSTEM

2.3.1 Capacity: 5.0 gal. (18.9 L.)
2.3.2 Type of Fuel: Regular unleaded gasoline, 87 octane or higher. In countries
using the research method, it should be a 90 octane minimum.
2.3.3 Fuel Filter: Replaceable in-line
2.3.4 Fuel Shut-Off Valve: 1/4 turn

2.4 ELECTRICAL SYSTEM:

2.4.1 Charging System: Flywheel Alternator
2.4.2 Charging Capacity: 15 amp
2.4.3 Battery Type: BCI Group U1 235 amps at O° F
2.4.4 Battery Voltage: 12 Volt; Polarity, negative ground.
2.4.5 Fuses: blade type, 20 amp to charging circuit; 20 amp to electric clutch.
2.4.6 Safety Interlock System: Operator must have OPC (Operator Presence Control)
levers held in contact with handle grips, speed control lever in neutral, and PTO
disengaged to start engine. Release of OPC levers will cause the engine to stop
if speed control lever is not in neutral and/or PTO is engaged.
Park brake must be disengaged to move speed control out of neutral or engine
will kill.
2.5 STEERING CONTROL:
Fingertip drive control levers provide independent speed control, braking and neutral
to each drive wheel for moving forward or reverse, stopping, and power turning.

2.6 TRANSMISSION:

2.6.1 Two Hydro Gear BDP-10A variable displacement piston pumps independently
coupled to two high efficiency Parker wheel drive motors.
2.6.2 Hydraulic Oil: Use Mobil 1 15W-50 Synthetic Motor Oil.
2.6.3 Hydraulic Oil Capacity: 2.4 qt. (2.2 L.)
2.6.3 Hydraulic Filter is replaceable cartridge type.
P/N 1-513211: 10 microns, 18 psi bypass (Summer use above 32° F (0° C))
P/N 1-523541: 40 microns, 18 psi bypass (Winter use below 32° F (0° C))
2.6.4 Speed Range:
2.6.5 Drive wheel release valves allow machine to be moved when the engine is not
running

2.7 WHEEL DRIVE SYSTEM:

Drive wheels are direct coupled to Parker wheel drive motors with 1.0" (25.4
mm) tapered shaft.
Forward 0 - 6.75 mph (10.9 km/h)
Reverse 0 - 2.25 mph (3.6 km/h)
- 10 -