Advertisement
SAFETYAND
WARNINGS
Thank you very much for purchasing this TV. To enjoy
your product from the very beginning, read this manual
carcfldly and keep it handy for easy reference.
INSTALLATION
• Locate tile TV in tile room where light does not strike
the screen directly.
• Total darkness or a reflection oil the picture screen can
cause eyestrain. Soft and indirect lighting is recommended
for comfortable viewing.
• Allow enough space between the TV and the wall to
permit ventilation.
• Axoid extreulely waml locations to prevent possible
damage to the cabinet or premature component
failure.
• This TV can be connected to AC ] 00-240 Volts. 50/60 tlz.
Never connect to a DC supply or any other power supply.
• Do not cover the ventilation
openings when using the TV.
CAUT1ON
Never tamper with any components
inside tile TV. or any
other adjustment
controls not mentioned in this manuah
All LCD-TVs
are high voltage instruments.
When you
clean up dust or water drops on the LCD PANEL or
CABINET. the power cord should be pulled out fronl the
receptacle, then wipe the TV with a dry soft cloth. During
thunder and lighting, unplug the power cord and antenna
cord to prevent damage to your TV. All repairs to this TV
should only be performed by qualified TV service personneh
Earthing
connection---
Tile apparatus shall be connected
to MAINS socket outlet with a protective earthing connection o
MAINS plug or appliance
coupler of the apparatus
is used
as disconnect
device,
it should remains readily
opembleo
Warning:
Change
or modifications
to this unit not expressly
by tile part responsible
%r conlpliance
could
void
tile user's
authority
to operate
tile Equipment.
NOTE:
This equipnlent has been tested and found to conlply with
the linlits for a Class 13digital device, pursuant to Part 15
of the FCC Rules. These linlits are designed to prnvide
reasonable protection
against harnlfifl interference
ill a
residential installation. This equipnlent generates, uses, and
can radiate radio frcquency energy and, if not installed and
used ill accordance with tile instructions,
nlay cause harnlfifl
interference
will not occur ill a particular
installation. If this
equipment does cause harnlfifl interference
to radio or
television reception, which can be determined
by turning
the equipment
off and oil, the user is encouraged
to try to
correct tile interference
by nile or more of tile f\)llowing
measures:
- Reorient or relocate tile receiving antenna.
- Increase tile separation between tile equipment
and receiver.
- Connect the equipment
into an outlet oil a circuit different
fl-om that to which tile receiver is connected.
-Consult tile dealer or an experienced radio TV technician
f\/r help.
Shield cables must be used with this unit to ensure
compliance
with the Class 13FCC limits.
_4_
Advertisement
