Troy-Bilt CS4265 Operator's Manual page 9

• Applyintermittent pressure ( force, i nshortpulses)
whilefeeding larger (2-3-inch diameter) branches
intothechipper c hute, t oavoid bogging orstalling
theengine.
IMPORTANT: Never f eedbranches witha diameter
greater t hanthree(3)inches intothechipper c hute.
Doing socanresult i nserious damage toyourunit's
chipper b lades, flailsorimpeller.
NOTE: For best performance, always operate the unit
with sharp chipper blades. If a noticeable loss in
performance is encountered while chipping branches,
the chipper blades should be replaced.
Emptying theDebrisCollectionBag
• Stop engine.
• Squeeze the locking buckle release the bag's
drawstrap before loosening it from the chute
deflector. See Figure 6.
• Empty the bag and reattach to the chute deflector
opening. Refer to Figure 2.
Figure 6
Locking Buckle
SECTION 5: MAINTAINING YOUR CHIPPER SHREDDER
Customer R esponsibilities
MAINTENANCE
SCHEDULE
/IIIII
SERVICE
DATES
Lube Spring Latch
b Lube Chipper Chute Hinge
tm Lube Chute Deflector
o
inspect Chipper Blades
i?
inspect Shredder Blade ,:,_,,
inspect for Loose Hardware
Check Oil Level
Change Oil
UJ
Z Clean Air Filter Precleaner
©
_ Clean Engine
Check Spark Plug
WARNING: Always stop engine, disconnect
spark plug, and ground against engine before
cleaning, lubricating or doing any kind of
maintenance on your machine.
Lubrication
Chipper Chute Hinge: Lubricate the hinge a with light
oil once a season.