Troy-Bilt CS4265 Operator's Manual page 5

SAFETY LABELS FOUND ONYOURUNIT
" ROTATING CUTTmNG BLADES. KEEP BANDS
AND FEET OUT OF OPENRNG WHILE
MACHINE IS RUNNING.
DO NOT OPERATE THIS MACHINE UNLESS
THE CHUTE DEFLECTOR HAS BEEN
PROPERLY RNSTALLED AND RS SECURED
WITH THE HAND KNOBS,
SECTION 2: ASSEMBLING Y OUR CHIPPER SHREDDER
IMPORTANT: This unit is shipped without gasoline or oil
in the engine. Be certain to service engine with gasoline
and oil as instructed in the Briggs & Stratton Owner/
Operator manual packed with your unit. before
operating your machine.
LoosePartsIn Carton
• Tow Bar (Model CS4210 Only)
• Debris Collection Bag
• Safety Glasses
• Engine Oil
Loweringthe Chipper Chute
For shipping reasons, the unit is crated with its chipper
chute in a raised position. To pivot it downward,
proceed as follows:
• Pull the spring latch upward and gently pivot the
chipper chute down until it clicks into the lock rod.
See Figure 1.
Spring Latch
Figure 1
,_ WARNING: Never operate the chipper
shredder with the chipper chute in the raised
position. Doing so may result in property
damage or serious injury to the operator or
bystanders.