Troy-Bilt 830 Series Operator's Manual page 6

NOTE: Stand behind
Ihe moweras if you
Jveregoing to operate
it, Your right hand cor-
esponds to the right
side of the mower; your
left hand corresponds
to the left side d the
mower.
NOTE: Forshipping
purposesyour mower
is set with the wheels
in a lowcutting
height position, For
best results raise the
cutting position until il
is determinedwhich
height is best for your
lawn. See Step 8 for
details.
IMPORTANT
DO NOT crimp the
cables when lifting the
handle up.
IMPORTANT
This unit is shipped
without gasoline or
oil in the engine. Fill
up gasoline and oil
manual BEFORE
Figure 1
zJ'i .........
Figure 2
1. Removegrasscatcherand anypackingmaterial
which maybe betweenupper and lowerhandles.
a. Removehandknobs from handlebracketsand
pull up and backon upperhandleas shown in
Figure1.Make certainthe lowerhandb is seated
securelyintothe handb mountingbrackets,
b. Tighten handknobs securingupperhandb to
lowerhandb. Makesure thateach carriagebolt is
seatedproperlyin the handb.
2. Replaceand tighten hand knobsremovedearlbr
securinglowerhandb to handlebrackets,SeeFigure
2.
3. The ropeguide is attachedto the right sideof the
upperhandb. Loosenthe wingnut whichsecuresthe
rope guide,See Figure3.
a. Holdthe bladecontrol againstupperhandle.
b. Pull starterrope outof the engine,Releasethe
bladecontrol.
c. Slip starterrope intorope guide,Tightenwingnut,
4. Attachcanes to the lowerhandb with the cane ties
alreadyon the lowerhandle.Insertpegson cane ties
intothe hobs on the lowerhandle.Pull cane ties tight
and cut off the extra,
5, Followstepsbelowto attachgrasscatcher:
a. Lift reardischargedoorand removemulching
baffle.
b, Placegrasscatcheron the pivot rod,Let go
of dischargedoor so that it restson the grass
catcher,See Figure4.
WARNING: Never operate mower
unless the hooks on the grass
catcher are firmly seated in the
slots on the handle bracket as°
semblies, and the rear discharge
door rests firmly against top of
the grass catcher.
Figure 3
Figure 4
operating your mower.
6