Using The Remote With Vcr Or Cable Tv Converter; Vcr And Cable Function Buttons - Toshiba ColorStream TP50G60 Owner's Manual

I INTRODUCTION ............
Using the Remote;with: VCR
or Cable TV Converter
• To control a TOSHIBA VCR, first set the TV/CABLENCR switch to "VCR." The buttons shown below will then control
the VCR. The rest of the buttons operate the TV as usual.
If you have another brand of VCR, you can probably program the Remote Control to control it. Details are on page 15.
• To control a cable TV converter, this Remote Control must be programmed to recognize the brand of your converter.
See page 15. The shaded buttons can be used to control the cable TV converter.
Set the "I'V/CABLENCR switch to "CABLE" whenever you want to control the cable TV converter.
Aim at the VCR or cable TV converter
TV/CABLE/VCR switch
CABLE: To control a cable
"IV converter
VCR: To control a VCR
Channel Number
Press the numbers to select
a channel.
STOP
Press to stop the tape.
REC
Pressto start recording.
LIGHT POWER
, TV _ Press to turn the VCR (or
-- CABLE MUTE I_tNIDEO TIMER
7VCR (_ (_ (_ cable TV converter) on.
Press again to turn off.
11111
FAV___AVA
PIP CH
REW FF
CHANNEL • / •
Press • to select the next
higher channel.
Press • to select the next
lower channel.
CH RTN
This button does not function
until you program the Remote
Control to enter the VCR code.
PLAY
J Press to begin tape playback.
FF
Press to rapidly advance a tape.
In playback mode, press to view
the picture moving rapidly
forward.
14
TVIVCR
Press to select the TV mode to
view one program while
recording another program.
REW
Press to rewind a tape.
In playback mode, press to
view the picture moving
rapidly in reverse.