Before Using The Remote Control; To Install The Batteries - Toshiba ColorStream TP50G60 Owner's Manual

I _ INTRODUCTION
Before Using the Remote
Control
With this Remote Control, you can operate your "IV and most VCR and cable box models regardless of the
manufacturer.
However, this Remote Control must be programmed to control other VCR and cable box brands. See page 15.
If you have a TOSHIBA VCR0your Remote Control has already been programmed for you.
Before attempting to operate your Remote Control, install the batteries according to "Battery installation" below.
Notes:
• After installing new batteries, the Remote Control will set itself to the codes for TOSHIBA TVs and VCRs. If you are
using the Remote Control to operate other manufacturer's equipment, you will have to reprogram those codes.
• This Remote Control may have functions not available on your VCR and cable box remote controllers.
These functions may or may not operate your VCR or cable box. Refer to the owner's manuals supplied with the
equipment to see which functions are available.
• The remote controller supplied with your VCR or cable box may have keys not duplicated on this Remote Control. If
you want to use these functions, please use the original remote controller.
Battery installation
Place the Remote Control face down and remove
the battery cover.
Press and slide
__move.
Insert two "AA" size alkaline batteries, matching
the + and - signs on each battery with the + and -
signs in the battery compartment.
CAUTIONS
• Do not throw your batteries into a fire. Dispose of
your batteries in a designated disposal area.
• Do not combine used batteries with new ones.
• Do not mix battery types.
Tips for best operation
• For optimum performance, aim the Remote Control
directly at the "IV from a distance within 16 feet (5 m),
and be sure there is no obstruction between the
Remote Control and the TV.
• If your Remote Control does not always operate the
TV as you wish, you probably need to replace the
batteries.Use alkaline batteries for longer use.
• If the Remote Control will not be used for a long
period of time or when the batteries are worn out,
remove the batteries to prevent leakage.
• Do not drop, dampen or disassemble the Remote
Control.
Slide the battery cover shut until the lock clicks.
13