Installing The Cooling Device; Installing Dimms - EVGA Classified SR-X User Manual

Installing the Cooling Device

There are many different cooling devices that can be used with this
motherboard. Follow the instructions that came with your cooling assembly.

Installing DIMMs

Your new motherboard has twelve (12) 240-pin slots for DDR3 DIMMs
(ECC or Non ECC). These slots support 1GB, 2GB, 4GB and 8GB DDR3
technology. There must be at least one DIMM slot populated in each red
bank to ensure normal operation. Use the following recommendations for
installing DIMMs.
Always start by populating the red slots first, it is recommended to mirror the
memory from CPU 0 to CPU 1. If only using CPU 0, do not use the slots for
CPU 1.
Note that there is only one gap near the center of the DIMM slot. This slot
matches the slot on the DIMM to ensure the component is installed properly.
Unlock a DIMM slot by pressing the module clips outward.
1.
EVGA Classified SR-X Motherboard
13