Table of Contents
Advertisement
(ANTENNA
CONNECTION
(_) ANTENNA CABLE
%
(_) 300 ohm/75 ohm
MATCHING TRANS-
FORMER
(_) 300 ohm
TWIN-LEAD CABLE
(_) 75-300
ohm
TRANSFORMER
1. Remove the Antenna Cable from the TV set. Connect it to the "VHF IN", "UHF IN" Terminal of the VCR.
2. Connect one end of the Antenna Cable and Twin-lead cable to the "VHF OUT", "UHF OUT" Terminal of the
VCRo
3. Connect the other end to the "VHF", "UHF" Terminal of the TV.
°
VHF Antenna
UHF Antenna
(A)
L
(B)
300 ohm
to 75 ohm
Transformer
(supplied)
F Connector
UHF
Twin-Lead
Cable
(supplied)
VHF
TV Set
J
O0
O0
t
t
_ni:
iqS:neSiegn:dte_t;nmeatnh?cMaideBsaend:nnd
Super-
75 ohm-
300 ohm
Matching
Transformer
(supplied)
•
If you are unable to use the
Coaxial Cable with one-touch
Type F connector, use a 75
ohm-300
ohm
matching
transformer.
Coaxial Cable with one-touch
type F connector (supplied)
AC 120V, 60Hz
NOTE TO CATV SYSTEM INSTALLER:
This reminder is provided to call the CATV system installer's attention to Article 820-22 of the NEC that
provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be con-
nected to the grounding system of the building, as close to the point of cable entry as practical.
In the above configuration, you can record programs from CATV channels as well as VHF channels 2 through
13. You can record programs from 117 CATV channels except scrambled channels.
Advertisement
Table of Contents
