Related Manuals for Toshiba M-5010
Summary of Contents for Toshiba M-5010
- Page 1 SHOULD YOUR UNIT REQUIRE SERVICE, PLEASE REFER TO "TOSHIBA SERVICE PROCEDURE" ON BACK COVER.
- Page 2 Thank you for purchasing the Toshiba M-5010 Video Cassette Recorder. It will accept any VHS cassette tape and can be used to record TV programs with its built-in tuner or to make home video shows with a Toshiba video camera. However, before using the unit, please read this owner's manual carefully to ensure optimum, trouble-free performance.
-
Page 3: Table Of Contents
NOTE:This VideoCassette Recorder i s compatible with anyVideoCassette Recorder b earing mark. Save the original shipping carton and packing materials; they will come in handy if you ever have to ship your VCR. For maximum protection, repack the set as it was originally packed at the factory. - Page 4 (ANTENNA CONNECTION (_) 300 ohm/75 ohm (_) ANTENNA CABLE (_) 300 ohm (_) 75-300 MATCHING TRANS- TWIN-LEAD CABLE TRANSFORMER FORMER 1. Remove the Antenna Cable from the TV set. Connect it to the "VHF IN", "UHF IN" Terminal of the VCR. 2.
-
Page 5: Channel Selection
(SET YOUR TELEVIS CHANNEL 1. Set your TV to channel 3 unless channel 3 is one of the TV stations in your area. If channel 3 is used in your area, set your TV to channel 4 and slide the VCR/VHF OUTput Channel Selector toward channel 4. The VCR/VHF OUTput Channel Selector is located on the rear panel at left side of the antenna connector. - Page 6 (IDENTIFICATION OF CONTROLS (FRONT) When cassette inserted, the flap appears Cassette Compartment with display shown below. FRONT LOMmNG SYSTEM EJECT Button -l_._rfl._,@.@_ POWER Button I--. Channel Indicators Channel Selector Buttons RECORD MODE Switch TIMER Button "SET"I s_T_Butt°n s__a, L"CLEAR" TIMER SELECTOR Button (CLOCK, START, END) Switch "MIN"...
- Page 7 Button (FORWARD PICTURE SEARCH) REW Button (REVERSE PICTURE SEARCH) PAUSE/STILL Button STOP Button 4,V.T,,O.Y I =" TOSHIBA 1?CHANNEL Infrared Remote Control Receiver _BIm REC Button TV/VCR Button EP Speed Indicator Indicates EP in REC and PLAY modes. OTR (One Touch Record)
- Page 8 '(SETTING PRESENT TIME This clock provides a 12-hour display. The time display brightness will automatically darken from 10 PM to 6 Example: Monday, 5:35 PM TIMERr" _ SET[_ SP _--" ;LOCK I PGM HOUR CLEAR TRACKING 6---', Set the Timer Press the SET Set the Hour.
- Page 9 (_) Turn the tuning knob so that the desired channel has excellent P_._II- o I_II picture and sound. L__J ;;_'_'_ TOSHIBA High Larger numbered channels knob to High. Smaller are found by rotating the numbered channels rotated to Low. Low, Replace the labels to match the new channel order.---,...
-
Page 10: Other Playback Modes
(VIDEO CASSETTE Recording And Playback • Only video cassettes with _ mark can be used. Performance] This VCR can record at two different speeds (EP mode: 1.11 cm/sec, and SP mode: 3.34 cm/sec.). Recording © It is preset for SP speed. The correct playback speed is selected automatically from among three Playback ©... - Page 11 RECORDING A TV PROGRAM Insert a video cassette. The cassette Turnthe TV poweron and set the Turn the VCR power on. VCR channel. (Channel3 indicator lamp flashes until the or 4) cassette is installed properly. POWER Confirm that the cassette tab is not •...
-
Page 12: Playback
PLAYBACK Turn the TV power on and set the Turn the VCR power on. Insert a video cassette correctly. VCR'channel. (Channel 3 or 4.) POWER See page 4 for the VCR channel. EP Speed Indicator • To stop playback: Press the STOP button. Pressthe PLAYbutton. -
Page 13: Slow Playback
I _1_1 REW FFI_ B m,_m._ S=*_. _ TOSHIBA 117CHANNEL 3. Picture Search Review or Cue allow playback at about 7 times the normal speed, and can be performedwith quick search. It is very convenient during search for a particular section on the tape. - Page 14 Present time -. 30 min --- 60 min --, 1=" I I • Used to specify the timer on time in units of 30 .tvEvr ==ll TOSHIBA minutes. (Max 3 hours) ,:_:.A_NEL 30 "-' 60 "-' 90 -- 120 "-' 150 --' SET button Timer Button •...
-
Page 15: Programmable Timer
(SETTING PROGRAMMABLE TIMER • Confirm the present time. If the present time is not correct, set it again. • Press the POWER button on. • Insert the cassette (Check that the cassette safety tab has not been removed.) • When setting the programmable timer, be careful not to overlap recording time zone. •... - Page 16 (7) Set the Timer Selector.switch to END_ (8) Set the timer off hour .............."PM 9" (9) Set t_netimer off minute .............."45" o:,_t5 _'=:- (10)Set the Timer Selector switch to CLOCK. The display returns to the present time display TIMER and the program number goes off.
- Page 17 (ONE TOUCH TIMER RECORDING The One Touch timer recording function permits unattended recording for a maximum of 3 hours. Also, each time the OTR button is pressed during normal mode the recording time is extended 30 minutes. When setting the time, timer off time can beset in 30 minute increments after setting the timer off time. Notes: 1.
- Page 18 "E" indicator lights (when the TIMER button is pressed). TIMER/COUNTER display: indication TIMER/COUNTER display changed with TIMER/COUNTER button. Timer Display O" -IL- _!-2i_! I-° ° Counter Display TOSHIBA Note: The counter operates even when it functions as a clock.
-
Page 19: Remote Control Operation
However, TV/VCR, POWER and CHANNEL up/down modes can be operated by s'nI.L remote control. TOSHIBA 2. When using remote control unit, press control buttons at intervals of about one second to ensure correct operation. 3. If the remote control unit is not to be used for a long period of time, remove the bat- teries to avoid possible damage from battery corrosion. -
Page 20: Camera Recording
,,F_I_ " ;." :,u-uu I..I- ° <1-- owmm. I1,- ltTC_A_iL TOSHIBA • To stop recording: Press the STOP button. Press the EJECT button to remove the cassette. • To stop recording temporarily during video • When a "beep" sounds during recording:... - Page 21 (_BEFORE CALLING SERVICE PERSONNEL Check the following items before requesting servicing. CORRECTIONS SYMPTOMS CAUSE Insert it firmly into the receptacle. Power Power supply does not turn Power supply cord is not plugged in. supply Turn the power switch off and wait •...
-
Page 22: Specifications
(SPECIFICATIONS Power Supply AC 120V ± 10% 60 Hz Power consumption 37 W (8 W with power off) External dimensions 428W × 95H × 375D mm Weight 7.8 kg Channels received VHF: Channels 2 to 13, A2, A 1,A to I UHF: Channels 14 to 83, CATV: Channels J to W, AA to Antenna input/output terminals VHF: 75 ohm F type connector, UHF: 300 ohm Signal system... - Page 23 MEMO...
- Page 24 UNITED STATES... Should your unit require service, CALL Toll Free 800-631-3811 for the nearest TOSHIBA Authorized Service Station. Please present your bill of sale to the Authorized Service Station when applying for warranty service. If service is not available in your local area, you are to contact...