Adjusting The Cutting Height - Toro Recycler 20074A Operator's Manual

Adjusting the Cutting Height
Adjusting the cutting height may bring you into contact with the moving blade, causing serious injury.
• Stop the engine and wait for all moving parts to stop.
• Do not put your fingers under the housing when adjusting the cutting height.
If the engine has been running, the muffler will be hot and can severely burn you. Keep away from the hot
muffler.
Adjust the cutting height as desired. Set the Dont wheels to the same height as the rear wheels (Figure 12).
in. (108mm)
I 3-7/8 in. (98mm)
3-1/2 in. (899rnm)
3-1/8 in. (79mm)
2-3/4 in. (70mm)
in. (60mm)
2 in. (51mm)
in. (41mm)
(32mm)
Figure 1 2
4-1/4 in. (108mm)
3-7/8 in. (98mm)
3-1/2 in. (89mm)
3-1/8 in. (79mm)
2-3/4 in. (70mm)
2-3/8 in. (60mm)
2 in. (51mm)
1-5/8 in. (41mm)
1-1/4 in. (32mm)
7O