Troubleshooting - Sony HT-DDW700 Operating Instructions Manual

If color irregularity is observed
again...
Phtce tile speaker further away from tile TV
set.
If howling occurs
Reposition tile speakers or turn down the
vohnne on the receiver.
On cleaning
Clean tile cabinet, panel, and controls with a
soft cloth slightly moistened with a mild
detergent solution. Do not use any type of
abrasive pad, scouring powder, or solvent,
such as alcohol or benzine.
If you have any questions or problems
concerning your receiver, please consult your
nearest Sony dealer.
Troubleshooting
If you experience any of the following
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem.
There is no sound, no matter which
component is selected, or only a very
low-level sound is heard.
Check that the speakers and ccnnponents
are connected correctly and securely.
Check that both the receiver and all
conlponents are turned on.
Check that MASTER VOLUME is not set
to "VOL MIN".
Check that the headphone is not
connected.
Press MUTING to cancel the muting
function.
Check that you have selected the correct
component with the input buttons.
The protective device on the receiver has
been activated. Turn off the receiver,
eliminate the short-circuit problem, and
turn on the power again.
There is no sound from a specific
component.
• Check that tile component is connected
correctly to the audio input jacks l\)r that
component.
• Check that the cord(s) used for the
connection is (are) flllly inserted into the
jacks on both the receiver and the
component.
• Check that you have selected the correct
component on the receiver.
52us