Settings - Sony HT-DDW700 Operating Instructions Manual

Error codes
When an error is detected during Auto
Calibration, an error code will appear on the
display cyclically after each measurement
process as follow:
Error code -_ blank display -_ (error code -_
blank display) a) -_ PUSH -_ blank display
-_ ENTER
a,Appears when there are more thau
oue
error code.
To rectify the error
1 Record
down the error code.
2 Press the control button.
a Press I/(.D to turn off the receiver.
4 Rectify the error.
For details, see "Error code and remedies"
below.
5 Turn on the receiver and perform Auto
Calibration again (page 21).
Error code and remedies
Error Explanation Remedies
code
ERROR 10 The mrdromneut Make sure the
is too noisy, environmmlt is
quiet during Auto
Calibration.
ERROR I1 The speakers are Placeyourspeakers
placed too near lurther away from
the optimizer the optimizer
microphone, microphone.
ERROR 20 The trout Check the front
speakers are not speakers
detected or only connection.
one front speaker
is detected.
ERROR 21 Only one Check the surround
surround speaker speakers
is detected, connection.
Warning codes
During Auto Calibration, the warning code
provides information on the measurement
result. The warning code will appear on the
display cyclically as follows:
Warning code -_ blank display -_ (warning
code -_ blank display) b) -_ PUSH -_ blank
display -_ ENTER
b)Appears when there are inure than one warning
code.
You can choose to ignore the warning code as
the Auto Calibration function will
automatically adjust the settings. You can also
change the settings manually.
To change the settings
manually
1 Record down the warning code.
2 Press the control button.
3 Press I/(.D to turn offthe receiver.
4 Follow the solution provided in the
"'Warning code and solution" (page 23).
5 Turn on the receiver and perform Auto
Calibration again (page 21).
22us