Sony HT-DDW700 Operating Instructions Manual page 54

Hide thumbs Also See for HT-DDW700:
Table of Contents

Advertisement

The FM reception
is poor.
• Use a 75-ohm
coaxial cable (not supplied)
to connect
the receiver
to an outdoor
FM
antenna
as shown
below. If you connect
the receiver
to an outdoor antenna,
ground
it against lightning.
To prevent a gas
explosion,
do not connect
the ground
wire
to a gas pipe.
Outdoor
FM antenna
Remote
control
The remote
does not function.
• Point tile remote
at the remote
sensor on
the receiver.
• Remove
any obstacles
in the path between
the remote
and the receiver.
• Replace
all the batteries
in the remote
with
new ones,
if they are weak.
• Make sure yon select the correct
input on
the remote.
Ground wire
(not supplied)
To ground
Radio
stations
cannot
be tuned
in.
• Check that tile antennas
are connected
securely.
Adjust the antennas
and connect
an external
antenna,
if necessary.
• The signal strength
of the stations
is too
weak (when
tuning in with automatic
tuning).
Use direct tuning.
• Make sure you set the tuning interval
correctly
(when
tuning in AM stations
with direct tuning).
• No stations
have been preset or the preset
stations
have been cleared
(when tuning by
scanning
preset stations).
Preset the
stations
(page 44).
• Press DISPLAY
repeatedly
on the receiver
so that the frequency
appears
on the
display.
There is no picture appears on the TV
screen or monitor.
• Make sure you hu_,econnected the video
output of your video component to the TV.
Error messages
If there is a malfimction,
the display
shows a
message.
You can check the condition
of the
system by the message.
Refer to the following
table to solve the problem.
If any problem
persists, consult
your nearest Sony dealer. If an
error message
appears
while you perform
Auto Calibration,
see "Error
and warning
codes"
(page
22) to solve the problem.
DEC. EROR
Appears when a signal the receiver cannot
decode (ex. DTS-CD) is input and "DEC.
PRI." on the AUDIO menu is set to "DEC.
PCM". Set it to "DEC. AUTO" (page 30).
PROTECT
Irregular current is output from the speuket:s.
The receiver will automatically mm off after a
few seconds. Check the speaker connection
and turn on the power again.
54us

Advertisement

Table of Contents
loading

Table of Contents