Sony HANDYCAM DCR-TRV330 Operating Instructions Manual page 26

Checking the recording
- END SEARCHIEDITSEARCHIRec Review
You can use these buttons to check the recorded picture or shoot so that the transition
between the last recorded scene and the next scene you record is smooth.
_I + EDtTSEARCH- (_
ENDSEARCH
You can go to the end of the recorded section after you record.
Press END SEARCH in the standby mode.
The last 5 seconds of the recorded section are played back and returns to the standby
mode. You can monitor the sound from the speaker or headphones.
You can search for the next recording start point.
Hold down the +/ (@) side of EDITSEARCH in the standby mode. The recorded
section is played back.
+ : to go forward
- : to go backward
Release EDITSEARCH to stop playback. If you press START/STOP, re-recording begins
from the point you released EDITSEARCH. You cannot monitor the sound.
You can check the section which you have stopped most recentlv.
Press the (@) side of EDITSEARCH momentarily in the standby mode.
The section vou have stopped most recently will be played back for a few seconds, and
then your camcorder will return to the standbv mode. You can monitor the sound from
the speaker or headphones.
Notes
• END SEARCH, EDITSEARCH and Rec Review work only for tapes recorded in the
Digital8 I) system.
• If you start recording after using the end search function, occasionally, the transition
between the last scene you recorded and the next scene nray not be snrooth.
• Once you eject the cassette after you have recorded on the tape, the end search
function does not work.
If a tape has a blank portion in the recorded portions
26
The end search function may not work correctlv.