Sony DVP-C670D Operating Instructions Manual page 75

Sound
There is no sound,
,,_ Check that the player is connected securely.
The audio connecting cord is damaged. Replace it
with a new one.
Make sure you connect the player to the audio
input connectors on the receiver (amplifier). (page
10)
Make sure you turn on the TV and the receiver
(amplifier).
Make sure you select the appropriate input on the
receiver (amplifier) so that you can listen to the
sound from the playen
The player is in pause mode or in Slow-motion
Play mode. Press [_> to return to normal play
mode_
,,_ The player is in fast forward or fast reverse mode.
Press [_> to return to normal play mode.
,")" Check the speaker connections and setting (page
12, 67). Refer to the operating manual of your
receiver (amplifier).
If you use the DIGITAL OUT connectors, set
"DIGITAL OUT" to "ON" in the setup display.
Otherwise no sound will come from the DIGITAL
OUT connectors. (page 66)
Sound is noisy.
•'_ Clean the disc.
•,_ When you play a CD with DTS sound tracks, noise
will come from any connector other than the
DIGITAL OUT OPTICAL or COAXIAL connecton
(page 17)
Sound distortion occurs.
In the setup display, set "AUDIO ATT" in "AUDIO
SETUP" to "ON." (page 65)
The sound loses its stereo effect when you play a
VIDEO CD or a CD.
Set "AUDIO" to "STEREO" in the Control Menu
display. (page 35)
Make sure you connect the player correctly. (pages
8, 10, 12)
The surround effect is difficult to hear when you
are playing a Dolby Digital, DTS or MPEG sound
track.
-,_ Check the speaker connections and setting (pages
12, 67). Refer to the operating manual of your
receiver (amplifier).
Depending on the DVD, the output signal may not
be the entire 5.1 channels. It may be monaural or
stereo even if the sound track is recorded in Dolby
Digital, DTS or MPEG format.
The sound comes from the center speaker only.
Depending on the disc, the sound may come from
the center speaker only.
Set "VIRTUAL 3D SURROUND" to "OFF" in the
Control Menu display. (page 39)
Operation
The remote does not function.
-,_ Remove any obstacles between the remote and the
player.
"_ Use the remote near the playen
Point the remote at the remote sensor I on the
playen
•'_ Replace all of the batteries in the remote with new
ones if they are weak.
The disc does not play.
"$" There is no disc inside ("Insert disc." appears on
the TV screen).
Insert a disc.
•'_ Insert the disc correctly with the playback side
facing down on the disc tray.
• ,$"Clean the disc.
The player cannot play CD-ROMs, etc. (page 5)
Insert a DVD, a VIDEO CD, or CD.
Check the region code of the DVD. (page 4)
-,t, Moisture has condensed inside the player. Remove
the disc and leave the player turned on for about
half an hour. (page 6)
The player does not play from the beginning
when playing a disc.
•,,t, Program Play, Shuffle Play, Repeat Play or A-B
Repeat Play has been selected. Press CLEAR.
(pages 47 through 50)
Resume Play has been selected.
Press • on the front panel or on the remote before
you start playing. (page 19)
A title menu or a DVD menu automatically
appears on the TV screen when you play your
DVD, or a setup display automatically appears on
the TV screen when you play your VIDEO CD
with PBC functions.
D.
5"
3
o
75