Sony KP-51WS500 Operating Instructions Manual page 5

Installation
Water and Moisture
Do not use power-line operated sets
near water -- for example, near a
bathtub, washbowl, kitchen sink, or
laundry tub, in a wet basement, or
near a swimming pool, etc.
Accessories
Do not place the set on an unstable
cart, stand, table or shelf. The set
may fall, causing serious injury to a
child or an adult and serious damage
to the set. Use only a cart or stand
recommended by Sony for the
specific model of TV. No part of the
TV set should overhang any edge of
the TV cart or stand; any
overhanging edge is a safety hazard.
An appliance and cart combination
should be moved with care. Quick
stops, excessive force, and uneven
surfaces may cause the appliance
and cart combination to overturn.
Ventilation
The slots and openings in the cabinet and in the back or
bottom are provided for necessary ventilation. To ensure
reliable operation of the set, and to protect it from
overheating, these slots and openings must never be
blocked or covered.
Q
Never cover the slots and openings _,
with a cloth or other materials. _'_:_P
Never block the slots and openings by
placing the set on a bed, sofa, rug or
other similar surface.
Q
Never place the set in a confined -k ._ ,_
space, such as a bookcase or built-in _a_ _ cabinet, unless proper ventilation is
provided.
Power-Cord Protection
Do not allow anything to rest on or roll
over the power cord, and do not place the
set where the power cord is subject to
wear or abuse.
Antennas
Outdoor Antenna Grounding
If an outdoor antenna is installed, follow the precautions
below. An outdoor antenna system should not be located
in the vicinity of overhead power lines or other electric
light or power circuits, or where it can come in contact
with such power lines or circuits.
WHEN INSTALLING AN OUTDOOR ANTENNA
SYSTEM, EXTREME CARE SHOULD BE TAKEN TO
KEEP FROM CONTACTING SUCH POWER LINES
OR CIRCUITS AS CONTACT WITH THEM IS
ALMOST INVARIABLY FATAL.
Be sure the antenna system is grounded so as to provide
some protection against voltage surges and built-up static
charges.
Section 810 of the National Electrical Code (NEC) in
USA and Section 54 of the Canadim_ Electrical Code in
Canada provides information with respect to proper
grounding of the mast and supporting structure,
_ounding of the lead-in wire to an antenna discharge
unit, size of grounding conductors, location of antenna
discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode.
Antenna Grounding According to the
National Electrical Code, ANSI/NFPA 70
___ _Antenna lead-in wire
Li_ --_--_.,/ I 7 jtAntenna discharge unit
] Electdc_-_._j,-i
][_/ i (NECSection810-20)
service I
_(_ eent -. _.JGrounding conductors
......... __ (NEC section 810-21)
_._-'_'_-G round clamps
_,- - Power service grounding
NEC: National electrode system (NEC Art
Electrical Code 250 Part H)
Q Do not place the set near or over a Z---"#_:
radiator or heat register, or where it is _.- 2 _'-
exposed to direct sunlight.
5