Sony KV-27V26 Operating Instructions Manual page 9

Connecting a VCR and TV with a
cable box
1
Connect the single (input) jack of the
Splitter to your incoming cable connection,
and connect the other two (output) jacks
(using coaxial cable) to IN on your cable
box and VHF/UHF on your TV.
2 Using a coaxial connector, connect OUT
on your cable box to IN on your VCR.
3 Using AUDIO/VIDEO connectors,
connect AUDIO and VIDEO OUT on your
VCR to AUDIO and VIDEO IN on your
TV (Yellow-VIDEO, White-AUDIO Left,
Red-AUDIO Right).
Connecting to an S Video equipped
VCR with a cable box
(for optimum picture quality)
1-2
Perform as described above.
3 Using AUDIO connectors, connect AUDIO
OUT on your VCR to AUDIO IN on your TV
(White-AUDIO Left, Red-AUDIO Right).
4 Using an S VIDEO connector, connect S VIDEO
on your VCR to S VIDEO on your TV.
Note:
• To view scrambled channels through your
cable box, select VIDEO I by pressing TV/
VIDEO on the remote control.
Disconnect all power sources before making any connections.
I VCRmust be connected and turned on to operate PIP I
(KV-27S26, 27V26, 29RS26, 29R$26C, 29V66M,32S26,
I
32TW26, 32V26, 34RS26C, 35S26, 37R$26 only).
Coaxial cable
(Rear of TV)
VCR
Splitter Cable box
(not supplied)
:oaxial cable
VCR
Cable 1 ;_ _
Splitter Cable box
(not suppUed)
,AUDIO OUT
(v_lx)
- AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
f
VMC-810S/820S (not supplied)
(Rear of TV)
HF AU_"O OU_
(VAP#FIX)
_'_
,,u'_
S VIDEO
AUDIO-R (red)
YC-15V/30V AUDIO-L (white)
(not supplied)
1
!
RK-74A (not supplied)