Slope Operation; Thrown Objects; Moving Parts - Craftsman ZTS 7000 Operator's Manual

3.5
2O
Slope Operation
Operation on slopes can be dangerous. Using the unit on
a slope that is too steep where you do not have adequate
wheel traction (and control) can cause sliding, loss of
steering, control, and possible rollover. You should not
operate on a slope greater than a 3.5 foot rise over a 20
foot length (10 degrees).
Always mow up and down slopes, not across, and avoid
sudden turns or rapid speed changes. Reduce speed and
use extreme caution on ALL slopes.
Also, note that the surface condition you are on can
greatly impact your ability to safely operate this machine.
Operating on wet or slippery slopes can cause sliding and
loss of steering and control. Do not operate on slopes that
are slippery, wet, or have soft soil conditions.
If you feel unsure about operating the unit on a slope, don't
do it. It's not worth the risk.
Thrown Objects
This unit has spinning mower blades. These blades can pick up and
throw debris that could seriously injure a bystander. Be sure to clean
up the area to be mowed and remove objects that could be thrown by
the blade BEFORE you start mowing. Do not operate this unit without
the entire grass catcher or discharge guard (deflector) in place.
Also, do not allow anyone in the area while the unit is running! If some-
one does enter the area, shut the unit off immediately until they leave.
Moving Parts
This equipment has many moving parts that can injure
you or someone else. However, if you stay in the operator
zone (stay seated in the seat), and follow the safety rules
in this operator's manual, the unit is safe to operate.
The mower deck has spinning mower blades that can
amputate hands and feet. Do not allow anyone near the
unit while it is running! Keep safety devices (guards,
shields, and switches) in place and working.
To help you, the operator, use this equipment safely, it is
equipped with an operator-present safety system. Do NOT
attempt to alter or bypass the system. See your dealer
immediately if the system does not pass all the safety
interlock system tests found in this manual
5