Samsung SC-DC163 Owner's Instruction Manual page 126

I ENGLISH I
Troubleshooting
*:* If these instructions do not solve your problem, contact your nearest Samsung authorized service center.
_i_!iii_;_!i_!_:i_!_iiii_i!!ii_ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii _ii _ii _ii_ii _ii _ii _ii_i ¸
You cannot switch the DVD
Camcorder on. Check the Battery Pack or the AC Power adapter.
You have left the DVD Camcorder set to STBY for more than 5
The DVD Camcorder shuts off minutes without using it. To turn on the DVD Camcorder, press
automatically, the [Start/Stop] button.
The Battery Pack is fully exhausted. Replace it with the fully
charged battery pack.
The atmospheric temperature is too low.
Charge runs out quickly. The Battery Pack has not been charged fully.
The Battery Pack is completely dead, and cannot be recharged,
use another Battery Pack.
A vertical strip appears on the The contrast between the subject and the background is too
screen when recording a dark great for the DVD Carncorder to operate normally. Make the
background bright to reduce the contrast or use the BLC
background, function while you are recording in bright Surroundings.
The Viewfinder Iens has not been adjusted.
The image in the Viewfinder is Adjust the Viewfinder control lever until the indicators displayed
blurred.
on the Viewfinder come into sharp focus.
Check the Manual Focus menu.
Auto focus does not work.
Auto focus does not work in the Manual Focus mode.
When the power is turned off If the DC Adapter is connected, remove the cord, turn on
and then turned on, a blue the Power switch, and then connect it again. If the battery is
screen shows up instead of the connected, disconnect it, turn the Power switch to on, and then
screen, connect it again.