Connectingcable T - Samsung LN-T4053H Owner's Instructions Manual

Connecting Cable TV
To connect to a cable TV system, follow the instructionsbelow.
Cable without a Cable Box
1. Plug the incoming cable into the ANT 2 IN (CABLE) terminal on the back of the TV.
Because t hisTV iscable-ready, youdo notneed a cableboxto viewunscrambled c able channels.
Conneetinq to a Cable Box that Descrambles All Channels
1. Find the cable that is connected to the ANT OUT terminal on your cable box.
This terminal m ightbe labeled"ANTOUT +', " VHFOUT +, o r simply,'OUT".
2. Connect the other end of this cable to the ANT 2 IN (CABLE) terminal on the back of the TV.
Connectinq to a Cable Box that Descrambles Some Channels
If your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-
way splitter+an RF (A/B) switch, and four lengths of RF cable. (These items are available at most electronics stores.)
Find and disconnect the cable that is
connected to the ANT IN terminal on your
cable box.
>- This terminalmightbe labeled"ANTIN",
"VHFIN"or simply,"IN'+.
2. Connect this cable to a two-way splitter.
Connect an RF cable between the OUTPUT
terminal on the splitter and the IN terminal
on the cable box.
Incoming
cable
Splitter
incoming
cable
Splitter _==== =====t_
J
Cable BOX
Connect an RF cable between the
ANT OUT terminal on the cable box and
the B-IN terminal on the RF(A/B) switch.
Incoming
cable
Splitter
Cable Box Switch
Connect another cable between the other
OUT terminal on the splitter and the A-IN
terminal on the RF (A/B) switch.
incoming , u i_ Ol '
Cable BOX Switch
Connect the last RF cable between the
OUT terminal on the RF (A/B) switch and
the ANT IN terminal on the rear of the TV.
ANT IN
+o
cable Splitter _ rJ RF (A] '_" B)
Cable BOX Switch
After you have made this connection, set the A/B switch to the "A" position for normal viewing. Set the A/B switchto the "B" position to
view scrambled channels. (When you set the A/B switch to "B', you will need to tune your TV to the cable box's output channel,which is
usually channel 3 or 4.)