Dust Bag; Hose Blockage - Eureka 4320 series Owner's Manual

Household type
Hide thumbs Also See for 4320 series:
Table of Contents

Advertisement

HOW TO MAINTAIN
Disposable Dust Bag and Filters
The disposable dust bag plays a very important role in
the efficiency of a vacuum cleaner. The purpose of the
paper bag is to trap dirt. As the bag traps dirt, it must also
be porous enough to allow air to pass on through. If the
paper bag becomes clogged, no air can pass through the
cleaner and no cleaning can take place regardless of how
powerful the unit. Change the dust bag and check the
filters frequently. Some fine particles can restrict airflow
very quickly and will decrease performance even before
the bag appears to be full.
When vacuuming carpet fresheners or cleaners, powder,
plaster dust, or similar fine substances, the bag and filters
may require more frequent maintenance.
How To Replace Bags–Style AA Filteraire
NOTE: Turn off the switch and unplug the
electrical cord before changing dust
bag. Never operate the vacuum cleaner
without the dust bag or the filter.
NOTE: Style AA Filteraire bags must be used
to maintain HEPA grade filtration and
prolong the life of the HEPA filter. Also
use AA Filteraire bags to maintain Micron
grade filtration and prolong the life of the
Micron filter.
NOTE: Models without HEPA or Micron filter
option, may use Style AA bags rather
than Style AA Filteraire.
It may be more convenient to lower the handle to the floor
before changing the bag.
* We recommend using only Genuine Eureka Filteraire
Bags, part number 58623.
How to Check and Clear Hose Blockages
Low suction or poor pickup may be due to a blockage in the vacuum cleaner.
1. Remove hose and check suction at end of hose - if little or no suction, check disposable
dust bag. Change if needed. If no improvement proceed to step 2.
NOTE: Turn off the switch and unplug the electrical cord before clearing hose.
2. Remove the handle from the vacuum cleaner by removing the two screws and sliding
the handle towards the rear.
3. Once the handle is removed, disconnect the attachment hose from the unit by lifting
straight up on the hose adapter.
Check for any obstructions that may be in the hose. Any obstructions can be removed by
using a blunt instrument to clear the hose. Flexing the hose may help loosen the clog.
4. Reinstall the hose after clearing the clog. Make sure the hose is inserted into the top of
the vacuum cleaner before reattaching the handle.
NOTE: If no improvement in performance on carpet, proceed to following page.
8
(Continued)
A. Remove front cover. Grasp both sides of bag cover near
B. Grasp bag collar; pull down slightly and out to remove bag.
To Replace New Bag:
C. Fold sides of paper bag
D. Align bag collar hole and
E. Place bag collar corners
F. Tuck bag into bottom and along sides.
G. Replace front cover. Make sure disposable bag does not
To Remove Bag:
A
Front
Cover
top. Push thumbs against center of cover and pull out on
sides.
below bag collar.
notch with hose adapter.
on ledges. Push collar
to rear of compartment.
Check to be sure hose
adapter inserts into bag
collar.
catch under front cover.
B
E
D
1
1. Remove hose and check
suction at end of hose.
E
C

Advertisement

Table of Contents
loading

This manual is also suitable for:

4440 series4370 series4470 series

Table of Contents