Table of Contents
Advertisement
HOW TO ASSEMBLE
Step B Attach Handle
CAUTION: Do not catch cord under handle.
Groove
4
4. From rear of cleaner, align handle with groove and slide
onto cleaner. If necessary, use thumb and finger pressure
to slide handle into position.
5. Once handle is in place, check that the hose adapter tab
is completely secure under the ledge of the handle.
6. Attach handle with two 5/8 inch screws in the assembly
packet. Use either a slotted or Phillips ® head screwdriver.
7. Replace front cover.
Step D Check Disposable Dust Bag
8. Remove front cover,
grasp both sides of
bag cover near top.
Push thumbs against
center of cover and
pull out on sides.
9. Check to be sure the
paper bag collar is
secure with the hose
adapter inside the
paper bag collar.
10. Replace front bag
cover.
9
Hose
Adapter
Paper Bag Collar
4
(Continued)
Tab
5
Ledge
Groove
8
10
Step C Store Hose and Accessories
Carrying
Handle
Extension
Wand or
Wands
HEPA Filter
(on some
models)
Tabs
Hose
Retainer
Step E Store Electrical Cord
11. You will find your cord retainer either at the bottom of
the upper cord hook or on the handle above the upper
cord hook. Firmly push the electrical cord down into
either cord retainer. This will place the cord out of the
way the next time you vacuum.
12. Next wind the cord around the two cord hooks on the left
side of cleaner. On some models the upper cord hook turns
to release the cord. Turn the hook up to store the cord.
NOTE: For easier access to bag compartment,
when you store the electrical cord use a
figure 8 pattern.
13. Secure the plug to the cord to prevent unwinding.
Cord
11
Retainer
Combination
Tool
Hook
Crevice
Tool
11
Cord
Retainer
Cord
12
Hook
12
Cord
Hook
Advertisement
Table of Contents
