Tv + Vcr + Satellite Receiver - RCA F36444YX01 User Manual

C@nnect @ns Setup
TV + VCR + Satellite Receiver
1. Connect your Satellite Receiver to your TV
A. Connect tile audio/video cables. Connect tile audio cables (white and red) to tile INt l_ F2
AUDIO R and L jacks on tile back ot tile TV and to the Audio Output Jacks on tile
Satellite Receiver.
B. Connect tile video cable (yellow) to tile INPUT2 VIDEO jack on tile back of tile TV and
to tile Video Output Jack on tile sal_dlite receiver.
C. Connect S-Video cable (optional). Connect an S-Video cable to tile S-VIDEO jack on the
TV and to tile S-VIDEO jack on the satellite receiver. (An S-Video cable provides beuer
picture quality than a regular vide<) cable, but it is optional.)
Note: If you connect an S-Video cable, you must connect the audio cables to the INPUT1AUDIO R and
Ljacks on the back of the IV, not the INPUT2AUDIO iacks.
2. Connect coaxial cables to the Satellite Receiver
A. Connect tile coaxial cable from your cable nutlet, cable box, or antenna t() tile Input Jack
on y()ur satellite receiver (sometimes lal)eled IN FROM ANT).
B. Connect tile coaxial cable from your satellite dish antenna to tile Input Jack ()n y()ur
satellite recei'_er, (sometimes labeled SATELLrFE IN)
3. Connect the Satellite Receiver to the VCR and to the TV
A. Connect a coaxial cable to tile Output Jack (sometimes labeled OUT TO TV) on tile
samllite receiver and to tile Input Jack on lhe VCR (sometimes labeled IN FROM ANT),
B. Connect a coaxial cable to tile Output Jack on tile VCR (sometimes labeled OIT TO TV)
and to tile CABLE/ANTENNA jack on tile TV.
4. Connect G-LINK cable
If you haven't already done so, remov(, tile I)emo Pin from tile G-LINK jack. Then, conn(,ct
tile G-LINK cable to tile G-LINK jack on tile TV. Next step, place one of tile wands of tile
G-LINK cable lo work with your VCR (instructions are on page 14).
Go to page 14
Chapter
I 11