Battery Management - Ematic eGlide Steal User Manual

Battery Management

This device is powered by a built-in polymer
battery and is designed and manufactured to be
used and recharged frequently. As with all
batteries, the capacity of the battery reduces
each time it is charged/depleted. However, you
can prolong the battery's lifetime by following the
suggestions below:
Use your Tablet at least once a week.
Deplete and re-charge the battery fully at
least once per month.
Never leave the battery fully discharged for
a long period of time.
Always keep the device and the battery
away from heat.
The battery is not fully charged out of the box, so
it is recommended the battery be charged for at
least 4 hours before starting to use the device.
NOTE: The first two times the battery is
charged, it may take as long as 6 hours to
fully e the battery.
2 | Getting Started
Battery Indicator
The battery icon in the System Bar shows the
battery power level.
In the event the battery becomes low on power,
the follow will occur:
The battery icon will show no power
Device will power OFF automatically
Operation buttons will not respond
Red signal appears in right corner of device
Should any of the above conditions occur,
charge the battery before attempting to use the
device.
Charging the battery
1 Plug the power adapter into an electrical
wall outlet.
2 Connect the power adapter to the device's
power interface port to fully charge the
battery before use (approximately 4 hours).
a. While charging, the battery indicator
light in the system bar will fill
with an image of a lightning bolt.