Module Installation Procedures; Installing The Output Module Accessory - FARGO electronics HDPii User Manual

RESTRICTED USE ONLY

Module Installation Procedures

Installing the Output Module Accessory

Parts included: Output Module Accessory Kit, Torx tool and screws
Tools needed: Torx Tool (included in kit)
Estimated Repair Time: 20 minutes
Step Procedure
1
Caution: Power off the Printer by unplugging the power cord from
the Printer.
2 Remove all USB, Serial, and Ethernet communication connections. Remove
the Card Output Hopper.
Important: Do not remove the Covers for this procedure.
3 The Output Module is installed at the output side of the Printer.
4 a. Turn the Printer and the Output Module on their back.
b. Use the Torx tool provided to remove the two (2) screws from the bottom
of the Output Module. Save the screws for later for reattachment.
5 If the Printer Module has the Output Side Upgrade Cover installed, then
follow the Removing the Output Side Upgrade Cover (if applicable)
procedure (provided below these instructions).
6 Position the Output Module attachment tabs into the appropriate slots at the
base of Printer. See Display A (below).
7 Use the two (2) screws to attach the Output Module to the Printer. Please
refer to the pictures below.
HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1)
Fargo Electronics, Inc.
Continued on the next page
3-5