FARGO electronics Persona C30 User Manual page 66

RESTRICTED USE ONLY
Resolving the Mag Verify Error (continued)
Step Procedure
2 Check to ensure that the cards are loaded with the Magnetic Stripe facing Up
and towards the front of the Printer.
3 a. Press on the Resume button.
b. If the error continues continue to step 4
4 Verify the Driver settings if cards are loaded properly. See the
Magnetic Encoding tab (Persona C30)
5 Verify that data is being encoded to the Magnetic Stripe.
a. Clear any Error Messages by unplugging the Printer and reapplying power.
b. Remove the failed card.
c. Use a Magnetic Stripe reader or magnetic developer spray to determine if
data is being written to the Magnetic Stripe.
d. If data is not being written to the Magnetic Stripe,

Open the front cover.

Remove the Magnetic Module cover screw.

Remove the Magnetic Module cover.

Verify that the Magnetic Module is seated securely into the Magnetic
Module docking station.
e. If the Magnetic Module is properly seated, replace the magnetic head (as
needed). (Note: See the current Persona C30 User Guide for related
instructions in the Parts Replacement Section.)
f. If data is being written to the Magnetic Stripe, the Magnetic Offset may
need to be adjusted. See the
procedure.
6 Verify that the coercivity of the cards matches the Driver Settings.
Persona C30 Card Printer User Guide (Rev. 2.2)
procedure.
Using the Mag Top of Form Option
Fargo Electronics, Inc.
Using the
4-13