Programming The Remote; Testing The Remote - RCA F32690 User Manual

PROG RAMMI NG TH E REMOTE
: The universal Fem0te can be programmed to Control most brands of
remote controllable VCRsl satellite receivers and cable boxes. The
remote is already programmed to control most RCA, GE and
PROSCJ_I
TVs, VCRs, DVD players, laserdisc players and satellite receivers.
TESTI NG TH EREMOTE
Todetermine whether the universalremote needsto be. programmed;
turn a deviceON, suchasa VCR, point the remote at the VCR,and press
the VCR1 button. Then pressPOWERor CH ^ (channel up) or CH v
(channel down) to see if the VCR respondsto the remote commands.If
not, the remote needsto be programmed.
PROGRAMMING TH E REMOTE
Using Automatic Code Search
The following instructions can be used"to.program the remote to
control each of the devices connected to your TV./f you want to exit the
automatic code search without programming any of your devices, press
CLEAR until the LED turns off.
1. Turn on thedeviceyou want to control (VCR, SAT, etc:)
2. Pressand hold the button you want to program (VCR1, VCR2, etc.).
While holding the device button, press and hold ONeOFFuntil the
red light on the remote turns on, then release both buttons.
3. Pressand release PLAY, then wait 5 seconds or until the LED stops
flashing.
At this point the remote is searching for thecorrect code to.
program. If, after 5 seconds, the device you want to control does
not turn off, press PLAY again totell the remote to search the next
set of •codes.
Continue pressing PLAY untitthe device turns off or you have
searched through all of the codes.There are •20 total sets of codes.
If the device does not turn off after pressingPLAY 20 times, then
the remote cannot controlthat particular device.
If the device you wantto control does turn Off:
1. Pressand release REVERSE,then wait 2 seconds. Repeat this step
until the device turns back ON.
2. To finish, pressand hold STOPuntil the red light onthe remote
turns offi
Using Direct Entry
1. • 'Turn On thec0mponent to be programmed.
O'
RAY
v
You'll usethese buttons when you
program the remote to control any
device.
The remote may not •operate all models
of all brands.
• 22