Using The Who,Input Button - RCA 27GT730TX41AA4 Owner's Manual

Using the Remete Centrel
Tip
To turn off a!l the
RCA, GE, and
PROSCAN
components that are
connected to the TV,
press ON,OFF twice
within two seconds.
This feature only
works with most RCA,
GE and PROSCAN
products.
PAUSE If you're operating a VCR or DVD Player with the remote control, press PAUSE when the disc
or videotape is playing ro pause playback.
PLAY If you're operating a VCR or DVD Playe_, plays the disc or videotape.
REC,VCR+ When the GUIDE Plus+ program guide is on the screen, press REC-VCR+ ro program
your VCR to record a program. If tlae remote is in VCR mode, press REC'VCR+ ro start recording.
REVERSE If you're operating a VCR or DVD Player with the remote, control, press REVERSE ro go
backwards on a disc or videotape.
SAT*CABLE Puts the remote in SAT-CABLE mode. If you set up the Auto Tuning f_.arure (Chapter
3), pressing the SAT-CABLE button automatically runes the TV to the correct channel.
SKIP If you press this button belbre you change the channel, the TVwmts 30 seconds and
automatically goes back to the original channel. Each time you press SKIP, you add 30 seconds (i.e, if
you press SKIP two times before you change the channel, the TV waits 60 seconds and automatically
turns back m the original channel).
SOUND Displays the A UI)IO Pt{OCI_SSOt¢ menu.
STOP If you're operating a VCR or DVD Playm, stops playing the disc or videotape.
TV Turns on the TV and puts the remote in TV mode. Also displays channel inlormation.
VCR1 Puts the remora, in VCR mode. If you set up the Auto Tuning ti,ature (Chapr_.r 3), pressing the
VCR1 button automatically tunes the TV to the correct channel.
VCR2 Puts the remote in VCR mode. If you set up the Auto Tuning ti,ature (Chapr_.r 3), pressing the
VCR2 button automatically tunes the TV to the correct channel.
VOL (up and down) buttons Decrease or increase the TV's volume.
WHO*INPUT In TV mode, press WHO'INPUT to toggle through the available Video Input
channels (VID and the current channel). In SAT mode, press to select available channel lists.
Using the WHO.INPUT Button
Use the WHO-INPUT button ro toggle through the availahle input sources (VID and the current
channel) and view the content from the component you have connecr_.d to the TV.
1. Press TV to place the remote, in TV mode. Make sure that the content from the component is
turned ON.
2. Press WHO.INPUT m tune to the available input source and view the component.
3. Press WHO.INPUT again to tune back to the channel you were previously watching.
23