Pip Troubleshooting; Why You Should Use The Auto Tuning Feature; How To Set Up The Auto Tuning Feature - RCA F27669TX71AA14 User Manual

Using %% Features
11/(back panel)
You must use audio/video cables to connect
your VCR to your TV in order for PIP to work.
(VID) is
from VCR
PIP Trou bleshooti ng
The PIP ft'ature on this ['V only works if you connect a second vide() source (like a
VCR or satellite receiver), to your ['V with audio/video cables. If you use a cable
box, you may need extra equipment. Contact your cable company and/or go to
page 12 for more details about a cable box connection.
Swap won't work? Make sure the remote is in tim right mode. For example, once
you turn on the VCR with the VCR1 button, you can't S_G\P the pictures until you
put the remote in TV mode. Just press the TV button.
No signal or bad reception?
Most VCRs and satellite receivers have an antenna or
TV/VCR button. Press the antenna or ['V/VCR button on the front of the component.
Note: I['you prqgrammed the brlit'et.xal remote cotltrol to operate your I'CTL the
AN7"ENNA buttcm o_i the remote, acts as" a "l'lVl'Cl_ button.
EveW time you change channels, the same channel appears in both windows (the
main picture and the PIP picture).
A. Press the CH CY]'RL button on the remote until tim TV picture channel number
is highlighted (yellow). The channel [)_]t_)ns on your remote control won't
work correctly for PIP when the VII) channel is highlighted (yellow).
B. Tim only way to successfully change channels for the picture that is coming
fiom the channel on your VCR (the VII) channel), is to press the channel
buttons on the VCR or on the VCR's remote control.
To change the PiP channel, press the
channel buttons on the VCR. To change
the TV channel, press CH CTRL until the
TV channel is highlighted (yellow) and
press the CH up and down buttons.
With the auto tuning feature, you can set
up the TV to tune to the channel you
need to watch by pressing that
component's button.
Why You Should Use the Auto
Tuning Feature
The aut()-tuning t_ature autnnaatically tunes the TV to the correct channel tk>r
dit}k:rent components you have connecl_.d to your TV (like a VCR, DVD Player,
etc.) When you set up auto tuning in the menu system you d()n't have to
remember to change your TV lo channel 3, ['or example, when you want to
watch the tape in your VCR.
How to Set Up the Auto Tuning Feature
The way y()u set up the auto tuning tkmture in the TV's menu corresponds to
the comp()nent buttons ()n the rem()te and the way you have each c()mponent
connected lo your TV. When you set auto tuning, you're telling the TV what
channel to rune to when you press the VCR1, VCR2, DVD, or SAT*CABLE
buuon on the remote, control.
1. Press MEN[ (the TVMAh\,'Mtk_cU appears).
2. Highlight Cha*zneland press OK on y()ur remote contrnl.
3. Highlight Aulo Tz_ning and press OK.
38