Installation - Electrolux EQE6307SA User Manual

2 installation electrolux four-door refrigerator

Installation

1 To ensure adequate ventilation for your refrigerator, it
is recommended to provide space of 60mm on both
sides and at the back, and space of 90mm above the
refrigerator. Insufficient spacing will decrease cooling
efficiency, increase energy consumption and may reduce
the life of the unit (see page 3).
2 Using the two front adjustable feet, ensure that the
refrigerator is positioned firmly and level on the floor.
3 Using the adjustable feet, raise the front of the unit so it
leans back slightly, this will assist in door closing. Make
final adjustments to ensure that the doors are correctly
aligned.
When the left
door is raised
Lower the foot
at right side*
*Until the adjustable foot on the
other side is slightly off ground.
4 Remove the 4 screws from the bottom of the refrigerator
and use these to fit the kickplate (supplied inside the
refrigerator compartment).
Screw
(4 screws)
5 Connect the power plug to a 240 volt 10 amp power
point.
NOTES:
• Position your refrigerator so that the plug is accessible.
• Keep your refrigerator out of direct sunlight.
• D o not place next to a heat generating appliance.
• T his refrigerator is designed for indoor use only – do not
place the unit on an unsealed surface.
• T o avoid vibration and misalignment of the doors, the unit
must be level. Place the unit on a solid flat surface. Uneven
floors eg. slate, tiles and floorboards, can cause the unit to
sag over time causing the doors to become misaligned.
• I f the mains power is switched on when the door is open,
the door alarm will sound. Close the door to stop the alarm.
Adjustable feet
When the right
door is raised
Lower the foot
at left side*
Screw
Kickplate
When transporting
• Using the rollers, it is possible to move back and forth.
Carry the refrigerator by holding the holding devices
located on the rear and bottom.
Before using your refrigerator
• Clean the inside parts with a cloth soaked in warm
water. If soapy water is used, wipe it off thoroughly.