Zanussi ZKG 2105 User Manual page 18

IMPORTANT!
If an option which is not compatible with the set
wash programme is selected, the message Err
is displayed for few seconds and the red light
of this button flashes for 3 times.
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause
the washing machine by pressing button
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «O» and then to the new
programme position. Start the new programme
by depressing button
The washing water in the tub will not empty
out.
Interrupting a programme
8
Depress tbutton to interrupt a programme
which is running, the corresponding light starts
to flash. Depress the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «O» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
8
button .
9
If the light goes off, the door can be opened.
If it does not go off, this means that the
machine is already heating, that the water level
is above the bottom edge of the door. In this
cases the door cannot be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «O». The door can
be opened after few minutes.
18
8
.
8
again.
(Pay attention to the water level and
temperature!).
After this procedure, it will be necessary to set
the programme and the options again and then
8
to depress button .
At the end of the programme
The washer dryer stops automatically. Some
acustic signals sound and on the display will
appear a flashing «
0
9
the light go off. The door can be opened.
If, at the end of a programme, there is water in
9
the tub (light still on), to empty out the water
follow the following instructions:
To empty out the water:
1. turn the programme selector dial to «O»
2. select the Drain»or «Spin» programme
3. reduce the spin speed, if needed, by means
2
of the button
8
4. depress button
5. at the end of the programme, the display
shows a flashing zero «
off and it will be possible to open the door.
Turn the programme selector dial to «O» to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
8
». The button light and
9
», the light goes
0