Table of Contents
Advertisement
Front & Rear Panels —Continued
Rear Panel
1
B C D
COMPONENT VIDEO
IN 3
IN 2
IN 1
OUT
Y
P
B
P
R
IN
IN
OUT
L
R
CD
TAPE
O
P
Q
For detailed information, see the pages in parentheses.
A
COMPONENT VIDEO IN 1, 2, 3 (27, 29, 31)
These component video inputs can be used to con-
nect AV components with component video outputs,
such as DVD players.
B
AM ANTENNA (22)
These push terminals are for connecting an AM
antenna.
C
COMPONENT VIDEO OUT (26)
This component video output can be used to con-
nect a TV or projector with a component video
input.
D
FM ANTENNA (22)
This jack is for connecting an FM antenna.
E
RS232 (36)
This port is for connecting the AV receiver to home
automation equipment and external controllers.
F
IR IN/OUT (74)
These jacks are for connecting the remote sensors
included with multiroom kits (sold separately).
G
12V TRIGGER OUT A/B/C (69, 74)
These jacks can be connected to the 12-volt trigger
inputs on other components. These trigger outputs
can each be assigned to an input so that when that
input is selected, a 12-volt trigger signal is output.
H
A-BUS
A-BUS is a simple, efficient, elegant audio distribu-
tion system. The wiring installation time is signifi-
cantly reduced as only a single CAT-5 wire is run to
each location. A-BUS is easy to use, reliable,
10
E
H
9 J K
6
G
DIGITAL
IN3
IN2
IN1
OUT
COAXIAL
OPTICAL
RS 232
IN 2
IN 1
VIDEO 3
VIDEO 2
VIDEO 1
DVD
MONITOR
PRE OUT
IN
OUT
IN
OUT
IN
IN
OUT
V
SUB
WOOFER
S
IN
IN
IN
FRONT
SURR
CENTER
L
ZONE 2
OUT
OUT
OUT
SUB
R
WOOFER
VIDEO 3
VIDEO 2
VIDEO 1
DVD
R
S
T
U
L
M
ZONE 2 SPEAKERS
SURROUND BACK
SURROUND SPEAKERS
SPEAKERS
L
R
L
L
CENTER SPEAKER
R
R
FRONT SPEAKERS
REMOTE
CONTROL
V W
affordable, and most of all, far better sounding than
conventional auto former based volume controls.
ZONE 2 OUT: Use CAT-5 (eight conductor
twisted) cable to connect directly from the
receiver's A-BUS RI45 Hub to an A-BUS keypad.
Warning:
DO NOT connect A-BUS output to any computer or
network connections (i.e. ethernet). It will cause
damage to the computer or network components as
24-volt power runs on this same cable to power the
amplifier stages of the amplifier module.
IR OUT: Another feature of the A-BUS system is
the ability to control source equipment in another
room where the A-BUS module is installed. If you
wish to control another source from the receiver at
the A-BUS keypad by remote control, connect
A-BUS or another brands's IR emitter on the
receiver's 40 K terminal. Then place the emitter on
the remote receiver on the front panel.
Typically, the emitter will work when you connect
with a 40 K connector. If it does not work, try a
56 K connector.
DC IN: Connect A-Bus power supply. Do not use
any other AC Adapter on this connector as it may
cause severe damage to the receiver.
I
MONITOR OUT (26)
The S-Video or composite video jack should be
connected to a video input on your TV or projector.
N
L
R
X
Advertisement
Table of Contents
