Weider Pro 450 L 831.15948.0 User Manual page 6

ASSEMBLY
To watch an assembly
video, go to
http://productvideo.co/
assembly/sears/weider
or use your mobile phone
or your smartphone to
read the QR code at the
right.
Assembly requires two persons.
Due to its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
To identify small parts, see page 5.
In addition to the included tool(s), assembly
requires the following tool(s):
one adjustable wrench
one Phillips screwdriver
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1. Orient the Crossbar (2) as shown.
Attach the Crossbar (2) to one of the Uprights
(3) with two M10 x 80mm Screws (27); do not
tighten the Screws yet.
Attach the Crossbar (2) to the other Upright
(3) in the same way.
--3
Warning
6