Weed Eater EBV VS Instruction Manual page 8

KNOW YOUR ELECTRIC BLOWER
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERAT-
ING YOUR UNIT. Compare the illustrations to your unit to familiarize yourself with the
location of the various controls and adjustments. Save this manual for future refer-
ence.
ON/OFF Switch/___ _,_-_ Variable Speed Control
Cord (__ Air Vents
Retainerr._.___ I_( -- \t I
HR:nad, _ _ Upper Vacuum Tube
Inlet Cover Retaining Post
Latch
Tube Release Button
Blower Tube
{_._hlet Restrictor
ON/OFF SWITCH
The ON/OFF SWITCH is used to acti-
vate the motor.
INLET COVER LATCH
The INLET COVER LATCH is used to
open and close the inlet cover and to se-
cure the upper vacuum tube to the blow-
er unit.
BLOWER TUBE
The BLOWER TUBE is designed to di-
rect the flow of air.
INLET RESTRICTOR
The INLET RESTRICTOR improves tile
blower function.
Collection Bag
Elbow
Tube
Vacuum Assist Handle __._.,_
Upper Vacuum Tube
L
Lower Vacuum Tube
i
/
TUBE RELEASE BUTTON
The TUBE RELEASE BUqq-ON secures
the blower tube or elbow tube to the blow-
er unit during operation. Also, pressing
the tube release button allows removal of
the blower tube or elbow tube.
VARIABLE SPEED CONTROL
The VARIABLE SPEED CONTROL is
designed to allow an increase or de-
crease in motor speed as necessary
during blower use only. To avoid causing
damage to the unit, DO NOT attempt to
use the variable speed control during
vacuum use.
_WARNING: You MUST make sure
the tubes are secure before using the unit.
&WARNING: Do not use the unit
without the tubes or collection bag proper-
ly attached to avoid flying debris and/or
impeller contact which can cause serious
injury. Always wear eye protection to pre-
vent rocks or debris from being blown or
ricocheting into the eyes and face which
can result in blindness or serious injury.
STOPPING YOUR UNIT
To stop your unit, slide the ON/OFF switch
to the OFF position.
SWITCH POSITIONS
@@®
OFF VARIABLE HIGH
SPEED SPEED
STARTING YOUR UNIT
Your unit has two run positions, HIGH
(high speed) and VAR (variable speed).
Slide the switch to one of these
positions to turn on the unit.
8